Bosch Power Tools 4212L manual Unpacking & Checking Contents, Tools for Assembly & Alignment

Unpacking & Checking Contents

Before moving the saw: Lock the ! WARNING miter lock knob in 60° position. Lock

bevel lock handle. Lock head assembly in the down position.

Never carry the tool by the cord or head assembly power switch handle. Damage to insulation could cause an electric shock. Damage to wire connections could cause a fire.

Your new Model Miter Saw is shipped complete in one box, But you may need to make some adjust- ments and alignments before cutting final work- pieces.

Separate all parts from packing materials and check each one with the “Check List of Loose Parts” to make sure all items are accounted for before dis- carding any packing material.

Check List of Loose Parts:

■Clamp (Item #37 on page 8)

■Flip-Up Crown Stops (2) (Item #38 on page 8)

■Dust Elbow/Dust Bag (Item #36 on page 8)

■Multi Purpose Tool (See below)

■Miter Lock Knob (Item #11 on page 8)

■3mm Hex “L” Wrench (See below)

■10mm/17mm Combination Open-End Wrench (See below)

■Arbor Laser / 3x Battery / Arbor Laser Manual

!WARNING If any parts are missing, do not plug in power cord or turn the switch on

until the missing parts are obtained and are installed correctly.

Tools for Assembly & Alignment

Multi-Purpose Tool with Bit (4mm/Philips #2)

(supplied, stored on the right rear base)

Combination Square (not included)

10mm/17mm Combination Open End Wrench

(supplied)

3mm Hex “L” Wrench

(supplied)

1

3

2

Combination Square Must be True

1.Use the straight edge of a 3/4" thick board (this edge must be perfectly straight).

2.Draw a line on the board along this edge.

3.There should be no gap or overlap when the square is flipped over in dotted position.

10.