Bosch Power Tools 4212L manual Flip-Up Crown Stops Length Stop, For Use As Crown Stop

Saw Operations (continued)

Flip-Up Crown Stops /

Length Stop

This tool comes equipped with a left and a right flip- up crown molding stop. The stops can be stored behind the fence for normal cutting operations, used as a length stop, and can be easily flipped into posi- tion to be used as a crown molding stop.

Instructions for installing the crown molding stops:

1.Locate the included 2 (two) flip up crown molding/length stops (one left, and one right), 2 (two) knobs, and 2 (two) flat washers.

2.Hold one flip up crown molding/length stop to the side of the sliding base and mount by screwing one knob with washer through the slot of the stop and into the rear mounting hole as shown in figure 1.

NOTE: there are 2 (two) holes on the rib of the slid- ing base. Use rear hole for cutting most sizes of crown moldings. Use front hole ONLY for large crown moldings over 5-1/4” in size.

For Use As Crown Stop:

With the flip up crown molding stops now assembled to the tool, simply loosen the knob enough for the stops to move, position properly for use, and tighten.

For Storage On The Tool:

To move the stops out of the way for normal cutting operations, simply loosen the knob, slide the flip up crown molding/length stop all the way forward towards the front of the tool, flip it over the fence, slide the flip up crown molding/length stop into its resting position, and re-tighten the knob. (Figure 2). NOTE: for normal cutting operations without the crown stop, or length stop being used, keep the stock stop tab behind the stationary fence.

For Use As A Length Stop:

If the flip up crown molding/length stop is in the rear (storage) position, you can set the stop by simply unscrewing the knob and sliding the stop towards the front of the tool until it stops and retighten the knob (Figure 3).

!WARNING Use only one length stop. Using length stops on both sides of blade,

could trap workpiece and could cause workpiece to be thrown.

The length stop can be used when making repetitive cuts of the same length.

To set the cut length: unlock the base extension clamping lever, reposition the base extension and length stop, and relock the base extension clamping lever.

The maximum length that can be cut using the length stop is approximately 20”.

Crown Stop

Washer

Sliding	Front	Rear	Knob
Base	Hole	Hole

Figure 1: Crown Stop

Figure 2: Storage Position

Length

Stop

Figure 3: Length Stop

28.