Cisco Systems 815 manual Symptom Possible Causes

Page 62

Chapter 3 Troubleshooting

Problem Solving

Table 3-3	Troubleshooting the Power System (continued)

Symptom		Possible Cause(s)

The router is on, but the front panel		The power supply has failed.
PWR LED is off.

The front panel PWR LED is on, the		The power supply has failed.
front panel OK LED is off, and the
router does not pass console or EIA
data.

	Cisco 815 Integrated Services Router Hardware Installation Guide
3-12	OL-9558-01

Image 62

Contents Corporate Headquarters Page Cisco Systems, Inc. All rights reserved Page N T E N T S Installation Installing and Removing a Dimm C-4 ViiViii Audience and Scope OrganizationRelated Documentation Conventions Xii Xiii Xiv Page Xvi Xvii Commands XviiiCisco.com AccessibilityObtaining Documentation XixProduct Documentation DVD Ordering Documentation Documentation Store in the Cisco Marketplace at this URLXxi Documentation FeedbackCisco Product Security Overview Reporting Security Problems in Cisco Products XxiiXxiii Obtaining Technical AssistanceCisco Technical Support & Documentation Website Xxiv Submitting a Service RequestDefinitions of Service Request Severity Obtaining Additional Publications and Information XxvXxvi Key Features OverviewFeature Description Product Serial Number Location CiscoBack Panel Ports and LEDs Back Panel Ports and LEDsLabel/Color Description Front Panel LEDs WIC0 OKLED Label Color Description Router Memory Types of MemoryAmounts of Memory 815# show versionItems Included with the Cisco 815 Integrated Services Router Unpacking the RouterInstallation Before Installing the RouterConnecting the Router to Your Local Network Installation Connecting the Router to Your Local Network Connecting the Router to the Local Network Connecting Power to the Router Connecting the Power SupplyVerifying Your Installation Optional Installation Procedures Connecting a PCConnecting the Console Cable to the Router Connecting a Modem AUX port RJ-45 DB-9-to-DB-25 adapter Console cable ModemStacking the Router Assembling Stacking Clip and Fastener Stacking the Router Back View Unstacking the Router Unstacking the RouterOL-9558-01 Troubleshooting Contacting Your Cisco ResellerRecovering a Lost Password Determining the Configuration Register ValueConfiguration register is 0x2102 815# Resetting the Router Press Return. The following prompt appearsPrompt changes to the privileged Exec prompt Resetting the Password Resetting the Configuration Register ValueProblem Solving OK LED DiagnosticsTroubleshooting WICs and Cables Number of Blinks MeaningExample WIC-4ESW Troubleshooting the Power System Symptom Possible Causes Technical Specifications Operating Specifications Cabling Specifications Ethernet CablesEthernet Network Cabling Guidelines 10BASE-T 100BASE-TXSignal RJ-45 Pin DB-9 Pin DB-25 Pin Console Cable and AdapterOL-9558-01 Safety Warnings Opening the Chassis Figure C-1 Removing the Chassis Screws Installing and Removing a Dimm Locating ModulesRemoving a Dimm Release the latches Remove the DimmInstalling a Dimm Insert the Dimm Latches rotate to closed positionInstalling a VPN Module Screw StandoffFigure C-7 VPN Module Location Figure C-9 Retention Clip Location Figure C-10 Aligning the Retention Clip Center Post Figure C-11 Attaching the Retention Clip to the Motherboard Figure C-12 Securing the Standoff to the Router Motherboard Closing the Chassis Figure C-13 Attaching the Router Cover NumericsC IN-1ETH COL LED IN-2Dimm C-4 IN-3IN-4