Craftsman 315.220381 owner manual Installing the Front Table, See Figures 23A 23C, Hexnut

INSTALLING THE FRONT TABLE

See Figures 23A - 23C.

Use this procedure to install the fixed front table.

The top of the table has counterbored holes, predrilled from the top, around the center to attach the table. In the center are a counterbored hole and a small hole,

which is not counterbored. They are used for raising or lowering the center of the table until it is level.

•Locate the front table and the followinghardware: 1 tee nut

1 U-clip (1/4 in.)

1 setscrew (1/4-20 x 7/8 in.)

4 pan head screws (1/4-20 x 1 in.)

1 pan head screw (1/4-20 x 1-3/4 in.) 5 flat washers (5/8 in.)

4 lock washers (1/4 in.)

4 hex nuts (1/4-20)

•Place the front table on a solid worksurface,with the top surface face down. Race the tee nut in the

non-counterboredhole and tap it in place with a hammer.

SETSCREW
_			SCREW
f_l		_'_._,_	FLAT
r	I	_	WASHER
	ol	___	_k
			REAROF

U-CLIPAUGNU-CUP

OVERTHISHOLE

SAWBASE

Fig. 23B

•Place the long pan head screw into the center hole

and thread into the U-clip. Do not tighten until the table has been checked for evenness. See Figure

23A.

•Place the setscrew through the small leveling hole and thread intothe tee nut, but do not tighten.

ing holes and through the holes in the support. Cap with a lock washer and hex nut. Tighten with a

•7/16Put ain1.inwrench. long panand headphillipsscrewscrewdriverin the four. Thisremain- completes installationof the front table.

1-3/4 in. SCREW /

SCREW L	!'I /	ELAT
]	_' T' '	WASHER

REAROFFRONTTABLE Fig. 23A

•Snap the U-clip onto the front edge of the saw base. Line up the hole in the U-clip with the saw base hole just to the left of the center notch in saw base. See Figure 23B.

•Place the table, top up, on the table supportsso the center counterbored hole lines up over the hole in the U-clip.

•Place a flat washer in each counterborsd hole.

-i

HEXNUT

LOCKWASHER

Fig. 23C

[lll_NlUr RADIALSAW315.220381 32