Graco 395/490/495/595 important safety instructions If flushing with water, flush again with

Page 27

 

 

Operation

11. With prime valve horizontal. Trigger gun

 

 

into flushing pail to purge fluid from hose.

 

12.

Engage trigger lock.

 

 

 

ti24718a

 

20 s

15. If flushing with water, flush again with

 

mineral spirits or Pump Armor to leave a

 

 

protective coating to prevent freezing or

 

 

corrosion.

 

ti24649a

 

13. Turn pressure control knob to OFF and turn ON/OFF switch to OFF position. Disconnect power to sprayer.

ti24719a

16. Wipe sprayer, hose and gun with a rag soaked in water or mineral spirits.

ti24992a

14.Remove filter from gun and sprayer if installed. Clean and inspect. Install filter. See separate gun manual.

ti24720a

334530A

27

Image 27
Contents 334599 Related ManualsContractor/FTx SG3Contents Model ModelsHi-Boy Stand Lo-BoyExtension Cords GroundingFire and Explosion Hazard Equipment Misuse Hazard Personal Protective Equipment Stand Models Component IdentificationLo-Boy Models Hi-Boy Models Hi-Boy Models Pails Power RequirementsGrounding Extension CordsPressure Relief Procedure Trigger Lock 334530A SetupTi24638a Make certain ON/OFF switch is OFF Setup Startup Perform Pressure Relief Procedure20 s Spray Spray Tip InstallationPerform Pressure Relief Procedure, OperationClear Tip Clog Pressure Display Perform Pressure Relief Procedure, Digital DisplayStored Data Display Ti2824a Fast Flush Drain Tube CleanupTo flush drain tube and pump turn prime valve down Fast Flush Hose and GunIf flushing with water, flush again with Activity Interval MaintenanceTroubleshooting Mechanical/Fluid FlowRefer to this column Properly installed to allow full Possible during priming Error Code Messages Perform Pressure Relief Procedure,Electrical System see Pressure Relief Problem What to Check How to checkDisplays Code 03 message Step Ohms Motor thermal device When cool, correct cause Sprayer Will Not Run Sprayer Will Not RunOhms Sprayer Will Not Shut Off Troubleshooting ProcedureSee 395/490/495 Stand Sprayers132 395/490/495 Stand Sprayers Parts List Ref. Part DescriptionQty 395/490/495/595 Lo-Boy Sprayers 117 132 395/490/495/595 Lo-Boy Sprayers Parts List 395/490/495/595 Hi-Boy Sprayers 117 Ref. Part 395/490/495/595 Hi-Boy Sprayers Parts ListAlert  Accessories and LabelsControl Box Grommet Control Box Parts ListControl Box 120V, US/Japan Wiring Diagrams110V, UK 395/490/495/595 Technical SpecificationsNoise** dBa @ 70 psi 0.48 MPa, 4.8 bar For Graco Canada Customers Graco Standard WarrantyInternational Offices Belgium, China, Japan, Korea Graco Information