2.Fill hopper with water or compatible flushing solvent.
3.Plug sprayer in a grounded outlet.
4.Turn AllControl to
PRIME/CLEAN PUMP.
5.When sprayer starts pumping, water or flushing solvent and air bubbles will be purged from the system. Allow fluid to drain out of prime tube, into waste pail, until all fluid has drained out of hopper. Pour out any remaining fluid.
6.Turn AllControl to OFF.
7.Fill hopper with paint.
8.Turn AllControl to
PRIME/CLEAN PUMP.
Getting Started
9.When paint comes out of drain tube, turn AllControl to OFF.
ti9168a
ti9377a
10.Clip drain tube to side of hopper.
11.Point gun into waste pail.
ti9169a
ti9374a
12.Unlock gun trigger lock.
13.Pull and hold gun trigger.
ti8922a
ti9376a | 14. Set AllControl to |
| |
| PRIME/CLEAN GUN & |
| HOSE. |
ti9171a
15.Continue to trigger into waste pail until you see only paint coming out of gun.
ti9168a
16.Release trigger. Engage trigger lock.
ti8923a
ti9529a
17.If spraying, install tip and guard on gun, page 13 and see Spraying Techniques, page 14.
If rolling, roller setup and Rolling Techniques, begin on page 18.
ti9169a
10 | 312079A |