Graco 261800 specifications Turn off garden hose. Close Power Flush attachment

Page 27

Shutdown & Cleaning - After Direct Immersion Method Applications

Step 15 is for returning paint in hose back to paint pail. One 25-ft (7.5-m) hose holds approximately 1-pint (0.5-liter) of paint.

15.To preserve paint in hose:

a.Point gun into paint pail.

b.Unlock gun trigger lock.

ti8922a

c.Pull and hold gun trigger.

d.Turn AllControl to

PRIME/CLEAN GUN & HOSE.

ti9171a

e.Continue to hold gun trigger until you see paint diluted with water starting to come out of gun.

16.While continuing to trigger gun, quickly move gun to redirect spray into waste pail. Continue triggering gun into waste pail until water coming out of gun is

relatively clear.

ti9745a

 

17.Stop triggering gun. Engage trigger lock.

ti8923a

18. Turn AllControl to OFF.

ti9168a

19.Turn off garden hose. Close Power Flush attachment.

ti9413a

20.Unscrew Power Flush attachment from suction tube.

21.Use a soft brush to clean paint and debris off strainer and install strainer in hopper.

TIA

22.Follow Long Term Storage instructions, page 29.

23.Clean gun fluid filter (d) with water or flushing solvent and a brush every time you flush the system. Replace gun filter if damaged.

d

ti9257a

24.Clean tip and guard with water or flushing solvent. A soft brush can be used to loosen and remove dried on material if needed.

ti9671a

25.Wipe paint off outside of gun using a soft cloth moistened with water or flushing solvent.

26.Use a soft cloth to wipe off hopper, cover and hose.

312079A

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Project Painter 5 Airless Sprayer Fire and Explosion Hazard Equipment Misuse Hazard Installation Grounding and Electric RequirementsThermal Overload Project Painter Component IdentificationE1 M Pressure Relief Procedure Getting StartedTrigger Lock AllControl Settings SetupHopper Method Primary Spray Method Oil- or Water-based Materials Priming and Flushing Storage Fluid Hopper MethodPRIME/CLEAN GUN Direct Immersion Setup Alternate Spray Method Priming and Flushing Storage Fluid Direct Immersion Method Install Tip and Guard Preventing Excessive Tip Wear Adjusting PressureSpraying Techniques Unclogging Spray TipCoatings Choosing the Correct Tip for the JobTip Selection Selecting Tip Hole SizeReversible Tip Selection Chart Understanding Tip NumberTip Fan Width 12 Part Mm from Surface Getting Started With Basic Techniques Triggering GunAiming Gun Rolling Ceilings, Walls and Woodwork Rolling TechniquesRelieve pressure, Shutdown & Cleaning After Hopper Method ApplicationsRelatively clear and all Power Flush PRIME/CLEAN GUN and Hose Pail Flushing Pull and hold gun trigger Turn AllControl to Open Turn off garden hose. Close Power Flush attachment Cleaning Roller Storage Short Term StorageLong Term Storage Stowing Sprayer Problem Cause Solution TroubleshootingTroubleshooting Thermal Overload, Tips Maintenance and ServiceCaring for Sprayer Paint HosesTechnical Data For Graco Canada Customers Graco Standard Warranty
Top Page Image Contents