Graco 261800 specifications AllControl Settings, Setup, Hopper Method Primary Spray Method

Page 8

Getting Started

AllControl™ Settings

		OFF - turns motor off for short
STORAGE - long term and		term shutdown and relieves
STORAGE - long term and		system pressure
overnight shutdown and storage		system pressure
overnight shutdown and storage

PRIME/CLEAN PUMP - turns motor on and directs fluid to

prime tube HI SPRAY - uses high pressure

to direct fluid to spray gun

ROLL - directs low pressure

fluid to roller (when used)

SETTING INDICATOR - selects function

		PRIME/CLEAN GUN & HOSE -
LOW SPRAY - uses low pressure		PRIME/CLEAN GUN & HOSE -
LOW SPRAY - uses low pressure		directs fluid to gun and hose
to direct fluid to spray gun		directs fluid to gun and hose
to direct fluid to spray gun

Setup

Project Painter 5 can be used as either a hopper or direct immersion sprayer.

Hopper Method (Primary Spray Method)

3.Set AllControl to OFF. Engage gun trigger lock.

ti9168a

1.Stand sprayer upright to verify the suction tube is securely and properly connected to fitting (a) and hopper elbow (b). If they are not, connect suction tube and tighten securely.

a

b

ti9294a

4.Unscrew tip and guard assembly from gun.

ti9204a

5. Uncoil hose and connect

one end to gun. Use two

2. Return sprayer to horizontal position.

wrenches to tighten

securely.

ti9203a

8

312079A

Image 8

Contents Project Painter 5 Airless Sprayer Fire and Explosion Hazard Equipment Misuse Hazard Thermal Overload InstallationGrounding and Electric Requirements Component Identification Project PainterE1 M Trigger Lock Pressure Relief ProcedureGetting Started Hopper Method Primary Spray Method AllControl SettingsSetup Priming and Flushing Storage Fluid Hopper Method Oil- or Water-based MaterialsPRIME/CLEAN GUN Direct Immersion Setup Alternate Spray Method Priming and Flushing Storage Fluid Direct Immersion Method Install Tip and Guard Adjusting Pressure Spraying TechniquesUnclogging Spray Tip Preventing Excessive Tip WearChoosing the Correct Tip for the Job Tip SelectionSelecting Tip Hole Size CoatingsTip Fan Width 12 Part Mm from Surface Reversible Tip Selection ChartUnderstanding Tip Number Aiming Gun Getting Started With Basic TechniquesTriggering Gun Rolling Rolling Techniques Ceilings, Walls and WoodworkShutdown & Cleaning After Hopper Method Applications Relieve pressure,Relatively clear and all Power Flush PRIME/CLEAN GUN and Hose Pail Flushing Pull and hold gun trigger Turn AllControl to Open Turn off garden hose. Close Power Flush attachment Cleaning Roller Long Term Storage StorageShort Term Storage Stowing Sprayer Troubleshooting Problem Cause SolutionTroubleshooting Thermal Overload, Maintenance and Service Caring for SprayerPaint Hoses TipsTechnical Data Graco Standard Warranty For Graco Canada Customers