Graco 261800 specifications Open

Page 26

Shutdown & Cleaning - After Direct Immersion Method Applications

Power Flush

Power flushing is a faster method of flushing. It can only be used after spraying water-based coatings.

1.Relieve pressure, page 7.

2.If you used a spray gun, remove tip and guard assembly from gun and place in flushing fluid.

If you used a roller, leave roller assembly attached to gun.

3.Place waste and paint pails side by side.

ti9726a

4.Lift suction tube and prime tube from paint pail. Let them drain into paint for a while.

5.Place suction and prime tubes in waste pail.

6.Screw power flush attachment to garden hose. Close valve.

ti9413a

7.Turn on water. Open valve. Rinse paint off suction tube, prime tube and inlet screen.

9.Unscrew inlet screen from suction tube. Place inlet screen in waste pail.

TIA

10.Connect suction tube to Power Flush attachment. Leave prime

tube in waste pail.

TIA

11.Open lever on Power Flush attachment.

OPEN

TIA

12.Turn AllControl to

PRIME/CLEAN PUMP.

ti9169a

8. Turn lever to close power flush attachment.

ti9727a

13.Circulate water through sprayer, into waste pail for 20 seconds.

14. Turn AllControl to OFF.

ti9168a

26

312079A

Image 26

Contents Project Painter 5 Airless Sprayer Fire and Explosion Hazard Equipment Misuse Hazard Thermal Overload InstallationGrounding and Electric Requirements Component Identification Project PainterE1 M Trigger Lock Pressure Relief ProcedureGetting Started Hopper Method Primary Spray Method AllControl SettingsSetup Priming and Flushing Storage Fluid Hopper Method Oil- or Water-based MaterialsPRIME/CLEAN GUN Direct Immersion Setup Alternate Spray Method Priming and Flushing Storage Fluid Direct Immersion Method Install Tip and Guard Unclogging Spray Tip Adjusting PressureSpraying Techniques Preventing Excessive Tip WearSelecting Tip Hole Size Choosing the Correct Tip for the JobTip Selection CoatingsTip Fan Width 12 Part Mm from Surface Reversible Tip Selection ChartUnderstanding Tip Number Aiming Gun Getting Started With Basic TechniquesTriggering Gun Rolling Rolling Techniques Ceilings, Walls and WoodworkShutdown & Cleaning After Hopper Method Applications Relieve pressure,Relatively clear and all Power Flush PRIME/CLEAN GUN and Hose Pail Flushing Pull and hold gun trigger Turn AllControl to Open Turn off garden hose. Close Power Flush attachment Cleaning Roller Long Term Storage StorageShort Term Storage Stowing Sprayer Troubleshooting Problem Cause SolutionTroubleshooting Thermal Overload, Paint Hoses Maintenance and ServiceCaring for Sprayer TipsTechnical Data Graco Standard Warranty For Graco Canada Customers