Graco 261800 specifications Short Term Storage, Long Term Storage

Page 29

Storage

Short Term Storage

(up to 2 days)

1.Turn AllControl to OFF. Pause 2-3 seconds to allow pressure to be relieved, then turn to

STORAGE.

Pause

2-3 Seconds

ti9168a

ti9174a

 

2. Engage trigger lock.

ti8923a

3.Leave gun attached to hose.

4.Remove tip and guard and clean with water or flushing solvent. A soft brush can be used to loosen and remove dried on material if needed.

ti9671a

5.Wipe paint off outside of gun using a soft cloth moistened with water or flushing solvent.

Storage

Long Term Storage

(more than 2 days)

• Always circulate Pump Armor storage fluid through system after cleaning. Water left in sprayer will corrode and ruin pump.

Follow Shutdown and Cleaning instructions starting on page 20 or 23.

1.HOPPER METHOD: Place prime tube in waste pail. Pour 8 oz. of Pump Armor into hopper.

IMMERSION METHOD: Place suction tube in Pump Armor storage fluid bottle and prime tube in waste pail.

 

OR

 

TIA

Hopper Method

Immersion Method

2.Set AllControl to

PRIME/CLEAN PUMP.

ti9169a

3.When storage fluid comes out of prime tube (5-10 seconds) turn AllControl to OFF.

ti9168a

4.Wait 2-3 seconds to allow pressure to be relieved, then turn AllControl to STORAGE.

ti9174

312079A

29

Image 29
Contents Project Painter 5 Airless Sprayer Fire and Explosion Hazard Equipment Misuse Hazard Thermal Overload InstallationGrounding and Electric Requirements Project Painter Component IdentificationE1 M Trigger Lock Pressure Relief ProcedureGetting Started Hopper Method Primary Spray Method AllControl SettingsSetup Oil- or Water-based Materials Priming and Flushing Storage Fluid Hopper MethodPRIME/CLEAN GUN Direct Immersion Setup Alternate Spray Method Priming and Flushing Storage Fluid Direct Immersion Method Install Tip and Guard Spraying Techniques Adjusting PressureUnclogging Spray Tip Preventing Excessive Tip WearTip Selection Choosing the Correct Tip for the JobSelecting Tip Hole Size CoatingsTip Fan Width 12 Part Mm from Surface Reversible Tip Selection ChartUnderstanding Tip Number Aiming Gun Getting Started With Basic TechniquesTriggering Gun Rolling Ceilings, Walls and Woodwork Rolling TechniquesRelieve pressure, Shutdown & Cleaning After Hopper Method ApplicationsRelatively clear and all Power Flush PRIME/CLEAN GUN and Hose Pail Flushing Pull and hold gun trigger Turn AllControl to Open Turn off garden hose. Close Power Flush attachment Cleaning Roller Long Term Storage StorageShort Term Storage Stowing Sprayer Problem Cause Solution TroubleshootingTroubleshooting Thermal Overload, Caring for Sprayer Maintenance and ServicePaint Hoses TipsTechnical Data For Graco Canada Customers Graco Standard Warranty