Graco 261800 specifications Power Flush

Page 22

Power Flush

Power flushing is a faster method of flushing. It can only be used after spraying water-based coatings.

1.Relieve pressure, page 7.

2.If you used a spray gun, remove tip and guard assembly from gun and place in flushing fluid.

If you used a roller, leave roller assembly attached to gun.

3.Pour unused paint out of hopper and back into original container.

ti9292a

4.Place drain tube in waste pail.

ti9376a

5.Use inlet screen handle to remove inlet screen from hopper. Place in bucket of clean water or cleaning solvent.

ti9378a

6.Turn AllControl to PRIME/CLEAN PUMP to remove excess paint in hopper.

ti9168a

7.If you used a liner, carefully remove liner from hopper and dispose of liner in a proper trash container.

Shutdown & Cleaning - After Hopper Method Applications

8.Screw power flush attachment to garden hose.

ti9761a

9.	Thread hose extender into
	hopper inlet.
		ti9762a
10. Connect Power Flush
	attachment to hose extender.
		ti9743a
11. Turn water on and open
	valve.
		ti9744a
12.	Turn AllControl to
	PRIME/CLEAN PUMP. Let
	water flow out of drain tube,
	into waste pail for 30
	seconds.	ti9169a
	seconds.
13.	Turn AllControl to OFF.
14.
	a. If you used a spray gun
	only, continue with Step	ti9168a
	14.

b. If you used a roller follow Cleaning Roller instructions beginning on page 28.

Step 15 is for returning paint in hose back to paint pail. One 25-ft (7.5-m) hose holds approximately 1-pint (0.5-liter) of paint.

22

312079A

Image 22

Contents Project Painter 5 Airless Sprayer Fire and Explosion Hazard Equipment Misuse Hazard Grounding and Electric Requirements InstallationThermal Overload Component Identification Project PainterE1 M Getting Started Pressure Relief ProcedureTrigger Lock Setup AllControl SettingsHopper Method Primary Spray Method Priming and Flushing Storage Fluid Hopper Method Oil- or Water-based MaterialsPRIME/CLEAN GUN Direct Immersion Setup Alternate Spray Method Priming and Flushing Storage Fluid Direct Immersion Method Install Tip and Guard Unclogging Spray Tip Adjusting PressureSpraying Techniques Preventing Excessive Tip WearSelecting Tip Hole Size Choosing the Correct Tip for the JobTip Selection CoatingsUnderstanding Tip Number Reversible Tip Selection ChartTip Fan Width 12 Part Mm from Surface Triggering Gun Getting Started With Basic TechniquesAiming Gun Rolling Rolling Techniques Ceilings, Walls and WoodworkShutdown & Cleaning After Hopper Method Applications Relieve pressure,Relatively clear and all Power Flush PRIME/CLEAN GUN and Hose Pail Flushing Pull and hold gun trigger Turn AllControl to Open Turn off garden hose. Close Power Flush attachment Cleaning Roller Short Term Storage StorageLong Term Storage Stowing Sprayer Troubleshooting Problem Cause SolutionTroubleshooting Thermal Overload, Paint Hoses Maintenance and ServiceCaring for Sprayer TipsTechnical Data Graco Standard Warranty For Graco Canada Customers