Graco 261800 specifications Direct Immersion Setup Alternate Spray Method

Page 11

Direct Immersion Setup (Alternate Spray Method)

1. Set AllControl to OFF.

ti9168a

2.Push down on bend of handle and pivot 90°. Remove cover.

ti9290a

ti9291a

3.Use inlet screen handle to unscrew and remove inlet screen from hopper.

ti9302a

4.Unclip drain tube from side of hopper.

ti9828a

Getting Started

7.Unscrew suction tube fitting from hopper elbow

(b).

b ti9379a

8.Install inlet screen into end of suction tube.

ti9824a

9. Engage gun trigger lock.

ti8923a

10.Unscrew tip and guard assembly from gun.

ti9204a

5.Replace hopper cover and return handle to locked position.

6.Stand sprayer upright in immersion spray position.

ti9294a

11.Uncoil hose and connect one end to gun. Use two wrenches to tighten securely.

ti9203a

12.Connect other end of hose to sprayer. Use two wrenches to tighten securely.

ti9375a

If hose is already connected, make sure con- nections are tight.

312079A

11

Image 11
Contents Project Painter 5 Airless Sprayer Fire and Explosion Hazard Equipment Misuse Hazard Thermal Overload InstallationGrounding and Electric Requirements Project Painter Component IdentificationE1 M Trigger Lock Pressure Relief ProcedureGetting Started Hopper Method Primary Spray Method AllControl SettingsSetup Oil- or Water-based Materials Priming and Flushing Storage Fluid Hopper MethodPRIME/CLEAN GUN Direct Immersion Setup Alternate Spray Method Priming and Flushing Storage Fluid Direct Immersion Method Install Tip and Guard Preventing Excessive Tip Wear Adjusting PressureSpraying Techniques Unclogging Spray TipCoatings Choosing the Correct Tip for the JobTip Selection Selecting Tip Hole SizeTip Fan Width 12 Part Mm from Surface Reversible Tip Selection ChartUnderstanding Tip Number Aiming Gun Getting Started With Basic TechniquesTriggering Gun Rolling Ceilings, Walls and Woodwork Rolling TechniquesRelieve pressure, Shutdown & Cleaning After Hopper Method ApplicationsRelatively clear and all Power Flush PRIME/CLEAN GUN and Hose Pail Flushing Pull and hold gun trigger Turn AllControl to Open Turn off garden hose. Close Power Flush attachment Cleaning Roller Long Term Storage StorageShort Term Storage Stowing Sprayer Problem Cause Solution TroubleshootingTroubleshooting Thermal Overload, Tips Maintenance and ServiceCaring for Sprayer Paint HosesTechnical Data For Graco Canada Customers Graco Standard Warranty