Rolling
Setup
•Before assembling roller, follow Priming instructions, beginning on page 9 for Hopper Method or page 12 for Immersion Method.
•After priming, only paint should come out of spray gun. Water in hose line will cause paint to run.
1. | Set AllControl to lowest |
|
| ROLL setting. |
|
2. | If installed, remove tip and |
|
| guard assembly from gun. | ti9170a |
3.Make sure gasket is in place in bottom of roller frame.
ti9339a
4.Rest roller on flat surface and align gun with roller. Tighten nut with wrench while keeping gun and roller aligned.
ti9650a
Rolling
5. Unlock gun trigger safety. Trig- ger gun. Roll surface until paint is fully dispersed on roller. This may take a minute.
ti8922a
• Trigger gun briefly only when you need more paint.
•For best operating pressure set AllControl to the lowest ROLLER setting which provides an even paint supply to the roller.
6.Increase pressure only if triggering gun does not supply enough paint for your rolling speed.
7.Whenever you stop painting, relieve pressure, page 7 and elevate roller end of extension tube to prevent paint from draining out.
8.Flush the pump, gun and pressure roller imme- diately after each use to prevent paint from dry- ing in the pressure roller and damaging it. See Shutdown and Cleaning, beginning on page 20.
18 | 312079A |