Table of Contents | Graco 258880, 258864 specification

Table of Contents

Warnings	. 3	Basic Spraying Techniques	12
Component Identification	. 5	Triggering Sprayer	12
Common Procedures	. 6	Aiming Sprayer	12
Pressure Relief Procedure	. 6	Unclogging Spray Tip/Guard Assembly	13
Trigger Lock	. 6	Shutdown and Cleaning	14
Spray Tip Position	. 6	Flushing Sprayer	14
Prime/Relief Valve Position	. 6	Cleaning Sprayer Exterior	16
Charging the Battery	. 7	Tips	16
Charger Status Indicator Lights	. 7	Storage	16
Sprayer Status Indicator	. 7	Replacement Parts and Kits	17
Setup	. 8	Troubleshooting	18
Installing Suction Tube	. 8	Alternate Priming Method	21
Spraying Stains or Clear Coats		Inlet Valve Cleaning	22
(Fine-Finish Optimizer)	. 8	Technical Data	23
Sprayer Setup	. 9	Graco Standard Warranty	24
Materials	10
Install Tip/Guard Assembly
(if not installed)	11

Important User Information

Read this before using your sprayer. See the Operation Manual provided with your sprayer for complete instructions on proper use and safety warnings.

DO NOT RETURN THIS SPRAYER TO THE STORE!

If you experience problems, contact Graco Customer Service at 1-888-541-9788.

Congratulations! You have purchased a high-quality paint sprayer made by Graco Inc. This sprayer is designed to provide superior spray performance with water-based and oil-based (mineral spirit-type) architectural paints and coatings. This user information sheet is intended to help you understand the types of materials that can and cannot be used with your sprayer.

Before using this equipment, be sure to read and follow the information on your container label and ask for a Material Safety Data Sheet (MSDS). The container label and MSDS will explain the contents of the material and the specific precautions related to it.

Paints, coatings and clean-up materials generally fit into one of the following 3 basic categories:

WATER-BASED:The container label should indicate that the material can be cleaned up with soap and water. Your sprayer is compatible with this type of material. Your sprayer is NOT compatible with harsh cleaners such as chlorine bleach.

OIL-BASED:The container label should indicate that the material is combustible and can be cleaned up with mineral spirits or paint thinner. The MSDS must indicate that the flash point of the material is above 100° F. Your sprayer is compatible with this type of material. Use oil-based material outdoors or in a well-ventilated indoor area with a flow of fresh air. See the safety warnings in your Operation Manual.

FLAMMABLE: This type of material contains flammable solvents such as xylene, toluene, naphtha, MEK, lacquer thinner, acetone, denatured alcohol, and turpentine. The container label should indicate that this material is FLAMMABLE. This type of material is NOT compatible with your sprayer and CANNOT be used.

3A0705E