Fire and Explosion Hazard

Warnings

The following warnings are for the setup, use, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.

WARNING

Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help prevent fire and explosion:

• Sprayer generates sparks. Do not spray or flush with flammable liquids.

• Use only water-based or oil-based (mineral spirit-type) materials with a flash point greater than 100° F (38° C).

• Keep spray area well-ventilated. Keep a good supply of fresh air moving through the area.

•Use oil-based material outdoors or in a well-ventilated indoor area with a flow of fresh air.

•Do not spray or flush with combustible materials near an open flame or sources of ignition.

•Paint or solvent flowing through the equipment is able to result in static electricity. Static electricity creates a risk of fire or explosion in the presence of paint or solvent fumes. Keep sprayer at least 10 cm away from objects while spraying or flushing.

•Do not smoke in the spray area.

•Do not operate light switches, engines, or similar spark producing products in the spray area.

•Keep area clean and free of paint or solvent containers, rags, and other flammable materials.

•Know the contents of the paints and solvents being sprayed. Read all Material Safety Data Sheets (MSDS) and container labels provided with the paints and solvents. Follow the paint and solvents manufacturer’s safety instructions.

•Fire extinguisher equipment shall be present and working.

SKIN INJECTION HAZARD

High-pressure spray is able to inject toxins into the body and cause serious bodily injury. In the event that injection occurs, get immediate surgical treatment.

• Do not aim the sprayer at, or spray any person or animal.

• Keep hands and other body parts away from the discharge. For example, do not try to stop leaks with any part of the body.

•Always engage the trigger lock when not spraying. Verify the trigger lock is functioning properly.

•Always use the nozzle tip guard. Do not spray without nozzle tip guard in place.

•Use caution when cleaning and changing nozzle tips. In the case where the nozzle tip clogs while spray- ing, follow the Pressure Relief Procedure for turning off the unit and relieving the pressure before remov- ing the nozzle tip to clean.

•Do not leave the unit energized or under pressure while unattended. When the unit is not in use, turn off the unit and follow the Pressure Relief Procedure for turning off the unit.

•Check parts for signs of damage. Replace any damaged parts.

•This system is capable of producing 2000 psi. Use replacement parts or accessories that are rated a min- imum of 2000 psi.

•Do not carry the tool with a finger on the trigger.

•Verify that all connections are secure before operating the unit.

•Know how to stop the unit and bleed pressure quickly. Be thoroughly familiar with the controls.

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

•Always wear appropriate gloves, eye protection, and a respirator or mask when painting.

•Do not operate or spray near children. Keep children away from equipment at all times.

•Do not overreach or stand on an unstable support. Keep effective footing and balance at all times.

•Stay alert and watch what you are doing.

•Do not operate the unit when fatigued or under the influence of drugs or alcohol.

•Use only in dry locations. Do not expose to water or rain.

•Use in well-lit areas.

3A0705E