Graco 258880, 258864 important safety instructions Battery Hazard

Page 4

Warnings

WARNING

BATTERY HAZARD

The battery may leak, explode, cause burns, or cause an explosion if mishandled. Contents of an open battery can cause severe irritation and/or chemical burns. If on skin, wash with soap and water. If in eyes, flush with water for at least 15 minutes and seek immediate medical attention.

Do not short-circuit the terminals of the battery.

Keep the battery away from fire.

Charge only with Graco approved charger as listed in this manual.

Do not expose to heat above 170° F (80° C).

Do not expose battery to water or rain.

Do not disassemble, crush, or penetrate the battery.

Follow local ordinances and/or regulations for disposal.

CHARGER ELECTRIC SHOCK, FIRE AND EXPLOSION HAZARD

Improper setup or usage can cause electric shock, fire, and explosion.

Charge only Graco 18V Lithium Ion batteries; other batteries may burst.

Use only in dry locations. Do not expose to water or rain.

If the supply cord is damaged, it must obtained from the manufacturer to avoid a hazard.

Ensure that the outside surface of the battery is clean and dry before plugging into the charger.

Do not attempt to charge non-rechargeable batteries.

Place charger on flat non-flammable surfaces and keep away from flammable materials or fumes when recharging battery.

PRESSURIZED ALUMINUM PARTS HAZARD

Use of fluids that are incompatible with aluminum in pressurized equipment can cause serious chemical reaction and equipment rupture. Failure to follow this warning can result in death, serious injury, or property damage.

Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids containing such solvents.

Many other fluids may contain chemicals that can react with aluminum. Contact your material supplier for compatibility.

MOVING PARTS HAZARD

Moving parts can pinch or amputate fingers and other body parts.

Keep clear of moving parts.

Do not operate equipment with protective guards or covers removed.

Pressurized equipment can start without warning. Before checking, moving, or servicing equipment, follow the Pressure Relief Procedure in this manual. Disconnect power.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swallowed.

Read MSDS’s to know the specific hazards of the fluids you are using.

Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

PERSONAL PROTECTIVE EQUIPMENT

You must wear appropriate protective equipment when operating, servicing, or when in the operating area of the equipment to help protect you from serious injury, including eye injury, hearing loss, inhalation of toxic fumes, and burns. This equipment includes but is not limited to:

Protective eyewear, and hearing protection.

Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer.

4

3A0705E

Image 4
Contents 3A0705E Table of Contents Fire and Explosion Hazard Battery Hazard Component Identification Trigger Lock Pressure Relief ProcedurePrime/Relief Valve Position Charger Status Indicator Lights Charging the BatterySprayer Status Indicator Setup Installing Suction TubeInstallation Cleanup/StorageSprayer Setup Materials Starting a New Job or Refilling the CupInstall Tip/Guard Assembly if not installed Reversible Tip Selection ChartTriggering Sprayer Aiming SprayerUnclogging Spray Tip/Guard Assembly Shutdown and Cleaning Flushing SprayerWater or flushing fluid. a soft brush can be used to Storage Cleaning Sprayer ExteriorTips Replacement Parts and Kits Ref. Part DescriptionTroubleshooting Problem Cause SolutionSpray Pattern Diagnostics Problem Cause Solution Replace tip. See Install Tip/Guard AssemSpray pattern spits at Alternate Priming Method Inlet Valve Cleaning RemovalTechnical Data SprayerGraco Standard Warranty Graco Information