Graco 258864, 258880 important safety instructions Sprayer Setup

Page 9

Setup

Sprayer Setup

This sprayer arrives from the factory with a small amount of test material in the system. It is important that you flush this material from the sprayer before using it for the first time:

1. Fill material cup with water and thread onto sprayer.

ti14992a

5.Engage trigger lock and put prime/relief valve UP to release pressure.

ti14994a

ti14999a

6.Unscrew and remove material cup.

7.Disengage trigger lock, put prime/relief valve DOWN, hold sprayer slightly above material cup, and pull trigger to discharge fluid from pump.

2.Put prime/relief valve to UP position, then hold trig- ger in for 10 seconds.

ti14999a

3. Put prime/relief valve DOWN to spray position.

ti15425a

4.Reverse spray tip to UNCLOG position and trigger sprayer into a waste area.

ti14991a

ti15491a

ti15478a

8. Discard material in cup.

NOTE: If the sprayer is angled or tilted too far, the suction tube will lose contact with the material and the sprayer will stop spraying.

ti15511a

3A0705E

9

Image 9
Contents 3A0705E Table of Contents Fire and Explosion Hazard Battery Hazard Component Identification Pressure Relief Procedure Trigger LockPrime/Relief Valve Position Charging the Battery Charger Status Indicator LightsSprayer Status Indicator Installing Suction Tube SetupInstallation Cleanup/StorageSprayer Setup Starting a New Job or Refilling the Cup MaterialsReversible Tip Selection Chart Install Tip/Guard Assembly if not installedAiming Sprayer Triggering SprayerUnclogging Spray Tip/Guard Assembly Flushing Sprayer Shutdown and CleaningWater or flushing fluid. a soft brush can be used to Cleaning Sprayer Exterior StorageTips Ref. Part Description Replacement Parts and KitsProblem Cause Solution TroubleshootingReplace tip. See Install Tip/Guard Assem Spray Pattern Diagnostics Problem Cause SolutionSpray pattern spits at Alternate Priming Method Removal Inlet Valve CleaningSprayer Technical DataGraco Information Graco Standard Warranty