If you have set a public DDNS (dyndns.com, no- ip.com or changeip.com), it may take 30 to 60 seconds until the IP address of the host name (URL) can be updated in the DNS.

When using the network by connecting an IP router to the main system, the network port has to be designated from the setup menu of the IP router. The main system uses 1494ports (554-2048) for the TCP communication. When using it by assigning IP addresses dynamically to the main system while using the DHCP function supported by the IP router, the port number for the IP address dynamically assigned from the setup menu of the IP router needs to be designated. When using an IP router, it is recommended to designate the IP address and port number to be assigned to the main system from the setup menu of the IP router, to set a fixed IP address for the connection mode of the main system, and to enter the IP address designated to the IP router. Please refer to the IP router manual or contact the manufacturer for the IP router setup method.

NTP Setup

NTP Setup

Primary Address

pool.ntp.org

 

 

Secondary Address

asia.pool.ntp.org

 

 

Connection Status

NTP Enable

Test

 

 

 

 

 

 

 

 

 

trying.. 0%

 

 

 

 

 

 

 

OK

Cancel

 

 

 

 

 

 

 

 

Move/Control

Select

Exit

NTP Setup is used to configure the system for network- based synchronization.Primary Address & Secondary Address Sets the NTP server address.

Connection Status

You can check the connection status with the NTP server by pressing “Test” after entering the NTP server address.

If the message “Success” is displayed, the NTP server is in the state possible to communicate; if the message “Failed” is displayed, it is not possible to communicate.

NTP EnableWhen using the NTP function, please check the “NTP Enable” box.

When the DVR system time prior to operating the NTP setup function is set faster than the NTP standard time (in other words, the DVR system time is set to a past time through the NTP setup), the recording function will not operate for the protection of previously recorded data. The recording function will operate normally from the point that the newly set time exceeds the original time value.

When the NTP function is in use, a time change can not be made from the time setup menu and it only allows setting the standard time zone.

The synchronization between NTP server and DVR system will be performed every hour.

38_ menu setup