Install Tip/Guard Assembly if not installed

Install Tip/Guard Assembly (if not installed)

Reversible Tip Selection Chart

MATERIALS

*Thin	Medium	Heavy
Thin stains,	Enamels, solid	Heavy latex
semi-transparent stains	stains, thin latex

311	315, 515	517

*Install Fine-Finish Optimizer, see page 8.

1.Engage trigger lock and put prime/relief valve UP to release pressure. Then remove Tip/Guard Assembly.

2.Install filter to Spray Tip/Guard Assembly (make sure filter is fully installed into sprayer). NOTE: Filter assem- bly is reverse-threaded. Turn left (or counter-clock- wise) to install. Turn right (or clockwise) to remove.

ti14775a

NOTICE

Make sure filter is completely screwed into the Tip/Guard Assembly to avoid splattering material or damage to the filter.

3.Firmly screw Tip/Guard Assembly onto sprayer. Tighten retaining nut until completely engaged with sprayer. If Tip/Guard Assembly is not fully tightened, poor spray results and possible damage to the sprayer could occur.

ti15490a

ti14994a

ti14999a

NOTICE

The tip is a permanently attached to the guard. Removing the tip from the guard will result in damage to tip assembly.

3A0705E