Cleaning Sprayer Exterior
•Wipe paint off outside of sprayer using a soft cloth moistened with water or flushing fluid.
Do NOT submerge the sprayer.
Storage
3.Reverse spray tip to UNCLOG position, put prime/relief valve DOWN to spray position, and aim sprayer into waste area. Pull trigger for
ti14991a | ti15425a | ti15418a |
4. Properly dispose of used Pump Armor mixture from material cup and rinse cup with water.
Tips
• Tips will require replacement depending on abrasiveness of paint.
• Do not spray with worn tip. See Troubleshooting, page 18.
Storage
NOTICE
Failure to store with sprayer with Pump Armor will result in operational problems the next time you spray. Always circulate Pump Armor through the sprayer after cleaning. Water left in the sprayer will corrode and damage the pump.
1.Dilute 4 oz. bottle of Pump Armor Concentrate with an additional 4 oz. of water in material cup.
4 oz
ti15442a
2.Thread cup into sprayer, put prime/relief valve to UP position and squeeze sprayer trigger for approxi- mately 10 seconds.
ti15001a
5.Store sprayer indoors in a cool, dry place. Store in an upright position only.
ti15438a
NOTE: For prolonged battery life, lithium ion batteries should be stored at half charge in an environment below 90° F (32° C).
16 | 3A0705E |