Dremel 335 Adjusting Routing Depth, Lower Adjustment Nut, Release Button Hand Grip, Depth Stop

DM 2610920458 2-04 2/19/04 12:24 PM Page 5

Adjusting Routing Depth

NOTE: When making deep cuts, especially plunge cuts away from the edge of the work- piece, it is recommended to make several successive cuts progressively deeper using the depth adjustment and depth scale rather than making one single deep cut.

The depth limiter can be adjusted for two depths.

1.Place your Dremel Rotary Tool and Router assembly on the workpiece.

2.Turn the upper adjustment nut upward

and turn the lower adjustment nut down- ward so depth stop is free to move (Fig. 5).

	Depth	Upper
FIG. 5
	Stop
		Adjustment
		Nut

Lower

Adjustment

Nut

3.Loosen the locking hand grip (Fig. 6). Slowly lower the tool until the router bit just touches the workpiece.

4.Tighten the locking hand grip to lock the tool in place.

5.Press and hold the release button so depth stop touches the router base.

FIG. 6

1

Release

Button

Hand

Grip

	FIG. 7 Depth
1st Routing Depth	Stop
	X

6.	Turn the depth stop upwards so	that	Upper
	measurement X equals the first desired
			Adjustment
	routing depth (Fig. 7).
			Nut
	NOTE: 1 turn equals .06" (1.5 mm)
7.	Turn the upper adjustment nut down
	snug against the router frame.
			X

2nd Routing Depth

8.Turn the depth stop upwards so that measurement X equals the second desired routing depth. Make sure upper adjustment nut turns with the depth stop, so it rises away from router frame (Fig. 8).

FIG. 8

X

Depth

Stop

9. Turn the lower adjustment nut up snug	Lower
against the router frame.	Adjustment
	Nut
NOTE: The upper adjustment nut must
	X
remain stationary when tightening the lower
adjustment nut.
	5