MDR-9D — MAINTENANCE
NEUTRAL POSITION ADJUSTMENT
Once the travel lever has veen set to neutral position with the engine running, the hydraulic brake is is operating and the roller should not move. If the roller inches forward or backwards with the lever in the neutral position,
1.Stop the engine and set the travel lever in the neutral position.
2.Unscrew the two lock nuts on the sides of the cable (Figures 38 and 39).
Figure 38. Unscrewing Right Lock Nut
Figure 39. Unscrewing Left Lock Nut
3.If the machine moves forward, screw the
4.Screw back the lock nuts on the
5.Start the engine and make sure that the roller does not inch forward or backward at the neutral position of the travel lever.
Figure 40. Adjusting the Turn-Buckle
If the neutral position of the travel lever and the neutral point of transmission do not match after adjusment is repeated, align as follows:
1.Loosen the hex socket head bolt used for mounting the control lever on the underside of the transmission (Figure 41).
2.For forward movement, move the control lever slightly to the left.
3.for backwards movement, move the control lever slighty to the right.