FUNCTIONAL DESCRIPTION
The FSNS100 Stapler is designed to install 18 ga. narrow crown staples of various lengths from 3/8" to 1" long. Narrow crown staples are loaded into the magazine from the top.
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated pressures between 70 and 120 PSI (Pounds per Square Inch)(4.8 to 8.3 BAR). The preferred system would include a filter, a pressure regulator, and an automatic oiler located as close to the tool as possible, within 15 ft/4.6 m is ideal.
All compressed air contains moisture and other contaminates that are detrimental to internal components of the tool. An air line filter will remove most of these contaminates and significantly prolong the life of the tool. If an
The tool is equipped with a 1/4" male “quick connector”. The tool must always be connected to the air supply with a coupling such that all pressure is removed from the tool when the coupling is disconnected.
PREPARING THE TOOL
Keep tool pointed in a safe direction when loading nails.
Never load nails with the contact trip or trigger activated.
1.After reading and understanding this entire manual, connect tool to air supply. (Fig. 22)
2.Depress latch and slide magazine cover open. (Fig. 23)
3.Insert a strip of approved fasteners. (Fig. 24) Orient fasteners with points down in the magazine.
4.Push magazine cover closed. (Fig. 25)
5.Observe the low fastener indicator (A) Fig. 26 and reload as needed.
6.Adjust directional exhaust deflector (A) Fig. 27, so that the exhaust air or debris will be directed away from the operator. Grasp the deflector and rotate it to the desired position for the current application.
Fig. 22
Fig. 24
Fig. 23
Fig. 25
7