Design Spot 250™
6.Press ENTER to confirm.
7.Press MODE/ESC to return to the main menu.
DFSE
- With this function you can restore the factory default settings of the fixture. All settings will be set back to the default values. Any edited scenes will be lost. When restoring the factory settings the unit must be set to the address that the unit was in when you started editing. When you confirm this function, the fixture will begin to
reload the original factory settings.
1.Access the main menu.
2.Tap the UP button until “SPEC” is displayed, press ENTER.
3.Tap the UP button until “DFSE” is displayed, press ENTER.
4.The display will show “ON/OFF.”
5.Press the UP button to display “ON” to activate this function, or “OFF” to deactivate this function.
6.Press ENTER to confirm.
7.Press MODE/ESC to return to the main menu.
FEED
-Use this function to activate the pan/tilt error correction.
1.Access the main menu.
2.Tap the UP button until “SPEC” is displayed, press ENTER.
3.Tap the UP button until “FEED” is displayed, press ENTER.
4.The display will show “ON/OFF.”
5.Press the UP button to display “ON” to activate this function, or “OFF” to deactivate this function.
6.Press ENTER to confirm.
7.Press MODE/ESC to return to the main menu.
FANS
- This function is used to change the functionality of the internal cooling fans. Follow the procedure below to access the fan menu:
©Elation Professional® | 34 | Design Spot 250™ |