Design Spot 250™
2. Safety Instructions
The Design Spot 250™ is an extremely sophisticated piece of electronic equipment. To guarantee a smooth operation, it is important to follow the guidelines in this manual. The manufacturer of this device will not accept responsibility for damages resulting from the misuse of this fixture due to the disregard of the information printed in this manual.
1.Always be sure that the fan and the air inlets remain clean and are never blocked. Allow about 6” (15cm) between this fixture and other devices or a wall to allow for proper cooling.
2.Never touch the fixture during normal operation. This can cause severe personal injuries and/or damage to the fixture.
3.Be sure to unplug the DESIGN SPOT 250™ from the power outlet before performing any service related issues.
4.Lamp Replacement; Allow at least 30 minutes after disconnecting main power before you open the DESIGN SPOT 250™. To prevent personal injury, never touch the lamp if you are not absolutely sure it has cooled.
5.Never look directly into the lamp beam. You risk injury to your retina, which may induce blindness.
6.Be sure to track and record the lamp running time. The lamp should be changed at the end of the specified lamp life, regardless of lamp output. You may also have to change the lamp if it shows any deformations or damage. The same is with all glass components, color filters, lenses and mirrors.
7.For safe operation, follow the Installation guide described in chapter two of this manual. Operating the DESIGN SPOT 250™ without suited safety aids such as safety cables or clamps can increase the risk of damage and/or personal injury.
8.Installation should only be performed by qualified and certified personal.
9.When mounting this fixture, use only the original rigging parts included with this fixture. Any structural modification will void the original manufactures warranty and
©Elation Professional® | 6 | Design Spot 250™ |