Elation Professional Spot 250 manual Design Spot

Design Spot 250™

at a time until the light is evenly distributed.

4.If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back in the reflector. "Push” the lamp out by turning each of the adjustment screws ("1, 2, 3”) counterclockwise turn until the light is bright and evenly distributed.

Please remember that a MSD 250/2 lamp is not a hot-restrike lamp therefore, you must wait approximately 15 minutes before you can attempt to strike the lamp once it has been turned off.

©Elation Professional® 12 Design Spot 250™