Design Spot 250™
with the construction of the lamp, the lamp may explode during prolonged extensive use. This risk is increased with age; added care is encouraged when dealing with older lamps. Thus, lamp should always be replaced at the end of their recommended duty cycle. Extreme caution should be used when operated this or any fixture fitted with a gas discharge lamp.
Never open this fixture while in use!
During the initial operation of this fixture, a light smoke or smell may emit from the interior of the fixture. This is a normal process and is caused by excess paint in the interior of the casing burning off from the heat associated with the lamp and will decrease gradually over time.
This device falls under
All electrical connections must performed by qualified personal.
Be sure the available voltage matches the voltage requirements of the unit.
Be sure the power cord is never crimped or damaged. If the power cord is damaged, replace it immediately with a new one of similar power rating.
Always disconnect from main power before performing any type of service or any cleaning procedure.
Only handle the power cord by the plug. Never pull out the plug by tugging the wire portion of the cord.
Please be aware that damages caused by manual modifications to the device are not subject to warranty.
©Elation Professional® | 5 | Design Spot 250™ |