F R O N T P A N E L
(1) Low-cut filter
An 18 dB filter with a cut-off frequency of 200 Hz in the side chain (only)‚ does not filter the audio path. This filter is used to prevent low frequency modulation (which often appears as pumping and breathing) by reducing the affects of wind‚ stage and handling noise. If it is used with bass-only program material‚ it could prevent the compressor from seeing the source. It does not require the external side-chain to be enabled.
(2) De-esser filter
This filter is named after its function—it helps remove the hissing in the “sss.” By increasing the compressor’s sensitivity to high frequency components (as in the s‚ c and k consonants) it acts more aggressively on these sounds without lowering normal speech levels. For this circuit to function properly‚ the compressor’s attack and release controls must be set to respond very quickly (minimum settings) and
amid- to high-compression ratio must be used. It does not require the external side-chain to be enabled.
(3)Bypass
To disable signal processing each channel of the CEL2A can be bypassed. The internal circuitry maintains input and output isolation even when bypassed‚ allowing the unit to function as an unbalanced to balanced converter if needed. To provide this feature‚ power must be on even when the unit is bypassed. A two-color status LED is provided to show the channel’s condition. When the unit is operating the LED is green (processing happening)‚ when the LED is red‚ the unit is bypassed.
(4) External Side-chain Enable
The side-chain is an insert loop inserted into the detector path so that the signal sent to the detector can be rerouted through an external device or replaced altogether. This switch enables the rear panel jack and external processing. It has no affect on the side-chain low-cut or de-ess filters‚ which operate independently‚ but any signal applied to the external jack will pass through them if they are enabled.
(5) Expander Threshold
This sets the level at which the downward expander begins operation. If the input signal drops below the thresholds set point‚ the expander fades it out according to the slope (ratio) set by the ratio control. The soft-knee design smooths the transition from off to active by dynamically shifting the slope through the transition point. The attack and release times are preset. An LED has been provided to show expansion activity.
(6) Expander Ratio (Gate)
The expander ratio is determined by dividing the input level by the output level. A ratio of 1:5 signifies that the output level has dropped five times as fast as the input (downward expanded). Ratios of 1:1.2 to 1:2 are typically used to eliminate background noise and to dampen room reverberations. Higher ratios are used when gating is required. Expansion is eliminated when the ratio is set to 1:1.