R E A R P A N E L
(18) AC Mains Input
Connect the appropriate line cord to this connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used. Operate only with the specified AC input voltage applied.
(19‚ 20‚ 26‚ 27) Balanced Outputs
XLR and 1/4" TRS‚
(21‚ 28) Input/Output
This unbalanced 1/4" TRS jack has both input and output signals. It is configured so that a standard (not cross wired) stereo shielded cable can be used to plug into the TRS insert of a mixer. (The tip is input‚ ring is output‚ which match the insert jack wiring of all current Peavey mixers.)
(22‚ 23‚ 29‚ 30) Balanced Inputs
XLR and 1/4" TRS balanced inputs for line level inputs. Pin 2 (tip) is the positive phase‚ pin 3 (ring) is the negative phase. If unbalanced inputs are used the negative phase must be grounded. The XLR and 1/4" jacks are wired directly in parallel.
(24‚ 25) Detector Side-chain Insert
A 1/4" stereo (TRS) jack which allows an external device to be inserted into the detector’s signal path or an alternate signal can be brought in to be used as a key. The tip has the send signal and the ring is the return input. A switch in the jack normally connects the return (ring) to the send (tip) until a plug is inserted. To use as a ducker‚ apply the controlling signal to the ring connection and adjust the compressor controls to set the amount and threshold.
7