Grizzly G1021 instruction manual Assembly, Overview, Optional Stand

Page 12

SECTION 4: ASSEMBLY

Overview

Most of your G1021 Planer has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.

TOOLS REQUIRED: Most of the tools required for assembly are included with the planer. However, you will also need a Phillips® and regu- lar screwdriver as well as feeler gauge for adjust- ments later on.

Figure 2. Stand crossbracing in place.

Optional Stand

To begin stand assembly, keep all the stand parts within easy reach. To ease assembly, build the stand upside down on a bench and then place it upright on the floor.

1.Place the stand top upside down on your bench.

2.Attach each of the four legs to the stand top with carriage bolts, washers and nuts provid- ed. Do not over tighten. The legs attach to the outside of the stand top. See Figure 3.

3.Attach each of the four braces to the stand legs with carriage bolts, washers and nuts provided. Do not over tighten. The braces attach to the inside of the legs. See Figure 2.

4.Flip the stand right side up and place on the floor. Check to see if the stand is symmetrical from two adjacent sides. Adjust if necessary and securely tighten all nuts.

Figure 3. Fully assembled stand.

-12-

G1021 15" Planer

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Planer Page Table Of Contents Adjustment Block Pattern Warranty and Returns Safety Safety Instructions For Power ToolsSafety Instructions For Power Tools Additional Safety Instructions For Planers Fusing Circuit Requirements220V Operation Grounding Extension CordsIntroduction CommentaryUnpacking Parts InventoryClean Up Site ConsiderationsAssembly OverviewOptional Stand Starter Switch Planer UnitTo Mount the Planer Handwheel Knife Setting Jig To Assemble the Knife Setting JIGTo Mount the Handwheel Extension Rollers Dust Port To Attach the Extension RollersTo Attach the Dust Port Adjustments Overview of planer adjustment controls G1021 15 PlanerTable Adjustment Gauge BlockTo Check Table Parallelism Knife Inspection To Inspect the KnivesKnife Setting To SET the KnivesTo Adjust the Chipbreaker Chip BreakerFeed Roller Height To Check Roller HeightTo Adjust Roller Height To Adjust Roller PressureFeed Roller Pressure To Adjust the BED Rollers Bed RollersTo Adjust the Chip Deflector Chip DeflectorTo INSPECT/ADJUST the Pulleys Anti-KickbackBeltsGearbox To Check Belt TensionTo Inspect the Gearbox Extension Rollers Extension RollersTo Adjust the Scale Thickness ScaleOperations Table LocksPower Feed HandwheelDepth Limiter Test Run Wood Species Type Shear PSIPlaning Difficulties Maintenance GeneralKnivesLubrication Fill DrainAdjustment Section Closure Troubleshooting Symptom Possible Cause Corrective ActionReference 145 79 80 146 See page 41-42 for Reference Number Listing See page 41-42 for Reference Number Listing Pulley Cover PK06M G1021 15 Planer Warranty and Returns
Top Page Image Contents