Grizzly G1021 instruction manual Handwheel Knife Setting Jig, To Mount the Handwheel

Page 14

Handwheel		Knife Setting Jig

The handwheel is used to raise and lower the planer table. Each complete revolution raises the table 5⁄32" (4mm).

TO MOUNT THE HANDWHEEL:

1.Place the handwheel over the keyed shaft on the planer body. Make sure the key on the shaft and the keyway on the handwheel line up. The handwheel shaft is at the front right of the planer. See Figure 6.

2.Press the direction scale over the keyed shaft so it fits into the depression in the top of the handwheel.

3.Secure the handwheel with the 10mm - 1.25 hex nut and washer provided.

Figure 6. Handwheel attachment.

The knife setting jig has been provided to make knife setting quick and easy. See Figure 7.

TO ASSEMBLE THE KNIFE SETTING JIG:

1.Snap one of the E-clips over the notch on one end of the knife setting rod.

2.Slide the cast aluminum knife setting jig brackets onto the rod.

3.Snap the other E-clip onto the notch at the other end of the knife setting jig rod.

Jig Rod

E-clip

Jig Bracket

Figure 7. Knife setting jig components.

CAUTION

Planer knives are dangerously sharp. Use extreme caution when working near cutting surfaces. Failure to exercise care while working near knives could result in severe injury.

-14-		G1021 15" Planer

Image 14

Contents Planer Page Table Of Contents Adjustment Block Pattern Warranty and Returns Safety Safety Instructions For Power ToolsSafety Instructions For Power Tools Additional Safety Instructions For Planers 220V Operation Grounding FusingCircuit Requirements Extension CordsIntroduction CommentaryUnpacking Parts InventoryClean Up Site ConsiderationsOptional Stand AssemblyOverview To Mount the Planer Starter SwitchPlaner Unit To Mount the Handwheel Handwheel Knife Setting JigTo Assemble the Knife Setting JIG To Attach the Dust Port Extension Rollers Dust PortTo Attach the Extension Rollers Adjustments Overview of planer adjustment controls G1021 15 PlanerTo Check Table Parallelism Table AdjustmentGauge Block Knife Inspection To Inspect the KnivesKnife Setting To SET the KnivesTo Adjust the Chipbreaker Chip BreakerFeed Roller Height To Check Roller HeightFeed Roller Pressure To Adjust Roller HeightTo Adjust Roller Pressure To Adjust the BED Rollers Bed RollersTo Adjust the Chip Deflector Chip DeflectorTo INSPECT/ADJUST the Pulleys Anti-KickbackBeltsTo Inspect the Gearbox GearboxTo Check Belt Tension Extension Rollers Extension RollersTo Adjust the Scale Thickness ScaleOperations Table LocksDepth Limiter Power FeedHandwheel Test Run Wood Species Type Shear PSIPlaning Difficulties Maintenance GeneralKnivesLubrication Fill DrainAdjustment Section Closure Troubleshooting Symptom Possible Cause Corrective ActionReference 145 79 80 146 See page 41-42 for Reference Number Listing See page 41-42 for Reference Number Listing Pulley Cover PK06M G1021 15 Planer Warranty and Returns