Grizzly G1021 instruction manual Extension Rollers Dust Port, To Attach the Extension Rollers

Page 15

Extension Rollers

 

Dust Port

 

 

 

 

 

 

The extension rollers can be attached now, but it may be easier to make all the necessary adjust- ments to the planer before attaching them.

TO ATTACH THE EXTENSION ROLLERS:

1.Use the hex bolts and washers to mount the extension rollers. See Figure 8. Ensure that the top of the rollers are above the extension roller frame.

2.Finger-tighten the mounting bolts for now. Alignment of the extension rollers with the table surface will be covered in the Adjustment Section.

Height Adjust

Setscrew

Mounting Bolt

The G1021 Planer features a 4" dust port for use with a dust collection system.

As with the extension rollers, you may find it more convenient to attach the dust port after making adjustments to the planer.

TO ATTACH THE DUST PORT:

1.Fit the dust port over the planer upper cover. Line up the mounting holes.

2.Use three M6 - 1.0 x 12mm hex bolts and nuts and six washers to secure the dust port to the planer upper cover. See Figure 9.

3.Use three M6 - 1.0 x 12mm cap screws and lock washers to secure the dust port to the planer body.

CAUTION

DO NOT attach the dust hood if you do not intend to connect the Model G1021 to a dust collection system. Accumulated wood chips could cause a malfunction, resulting in per- sonal injury or damage to the planer.

Figure 8. Extension roller attachment points.

Upper Cover

Mounting Bolt

Dust Port

Figure 9. Dust port assembly.

 

 

 

 

 

 

 

 

 

 

 

 

G1021 15" Planer

-15-

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Planer Page Table Of Contents Adjustment Block Pattern Warranty and Returns Safety Instructions For Power Tools SafetySafety Instructions For Power Tools Additional Safety Instructions For Planers Extension Cords FusingCircuit Requirements 220V Operation GroundingCommentary IntroductionParts Inventory UnpackingSite Considerations Clean UpAssembly OverviewOptional Stand Starter Switch Planer UnitTo Mount the Planer Handwheel Knife Setting Jig To Assemble the Knife Setting JIGTo Mount the Handwheel Extension Rollers Dust Port To Attach the Extension RollersTo Attach the Dust Port Overview of planer adjustment controls G1021 15 Planer AdjustmentsTable Adjustment Gauge BlockTo Check Table Parallelism To Inspect the Knives Knife InspectionTo SET the Knives Knife SettingChip Breaker To Adjust the ChipbreakerTo Check Roller Height Feed Roller HeightTo Adjust Roller Height To Adjust Roller PressureFeed Roller Pressure Bed Rollers To Adjust the BED RollersChip Deflector To Adjust the Chip DeflectorAnti-KickbackBelts To INSPECT/ADJUST the PulleysGearbox To Check Belt TensionTo Inspect the Gearbox Extension Rollers Extension RollersThickness Scale To Adjust the ScaleTable Locks OperationsPower Feed HandwheelDepth Limiter Type Shear PSI Test Run Wood SpeciesPlaning Difficulties GeneralKnives MaintenanceFill Drain LubricationAdjustment Section Closure Symptom Possible Cause Corrective Action TroubleshootingReference 145 79 80 146 See page 41-42 for Reference Number Listing See page 41-42 for Reference Number Listing Pulley Cover PK06M G1021 15 Planer Warranty and Returns
Top Page Image Contents