Grizzly G1021 instruction manual Adjustment Section

Page 35

Clean and lubricate the chain sprockets as need- ed. The gearbox oil should be checked before the first use. It is full when oil begins dribbling out of the fill hole. Oil should be replaced yearly. Use 80-90 Wt. gear oil in normal situations. Use 50 wt. motor oil for unheated, winter shops. See

Adjustment Section.

The lead screws and columns should be wiped of any grease and dust build up once a week. They should be relubricated with light machine oil. See

Figure 42.

The infeed/outfeed pressure setscrews double as lubrication ports for the rollers. Add 1-2 drops of light machine oil to all ports before each use. See Figures 43 and 44.

Lead Screw

Column

Lubrication Ports

Figure 43. Lubrication ports on top of machine.

Oil Can,

1-2 drops

Figure 42. Lead Screw inside of column.

Figure 44. Oiling lubrication ports.




G1021 15" Planer	-35-

Image 35

Contents Planer Page Table Of Contents Adjustment Block Pattern Warranty and Returns Safety Instructions For Power Tools SafetySafety Instructions For Power Tools Additional Safety Instructions For Planers Extension Cords FusingCircuit Requirements 220V Operation GroundingCommentary IntroductionParts Inventory UnpackingSite Considerations Clean UpOptional Stand AssemblyOverview To Mount the Planer Starter SwitchPlaner Unit To Mount the Handwheel Handwheel Knife Setting JigTo Assemble the Knife Setting JIG To Attach the Dust Port Extension Rollers Dust PortTo Attach the Extension Rollers Overview of planer adjustment controls G1021 15 Planer AdjustmentsTo Check Table Parallelism Table AdjustmentGauge Block To Inspect the Knives Knife InspectionTo SET the Knives Knife SettingChip Breaker To Adjust the ChipbreakerTo Check Roller Height Feed Roller HeightFeed Roller Pressure To Adjust Roller HeightTo Adjust Roller Pressure Bed Rollers To Adjust the BED RollersChip Deflector To Adjust the Chip DeflectorAnti-KickbackBelts To INSPECT/ADJUST the PulleysTo Inspect the Gearbox GearboxTo Check Belt Tension Extension Rollers Extension RollersThickness Scale To Adjust the ScaleTable Locks OperationsDepth Limiter Power FeedHandwheel Type Shear PSI Test Run Wood SpeciesPlaning Difficulties GeneralKnives MaintenanceFill Drain LubricationAdjustment Section Closure Symptom Possible Cause Corrective Action TroubleshootingReference 145 79 80 146 See page 41-42 for Reference Number Listing See page 41-42 for Reference Number Listing Pulley Cover PK06M G1021 15 Planer Warranty and Returns