Grizzly G1021 Feed Roller Pressure, To Adjust Roller Height, To Adjust Roller Pressure

Page 22

6.Repeat steps 1-5 for the opposite side of the roller. Repeat all steps for the outfeed roller.

Feeler gauge measurement should equal 0.040".

TO ADJUST ROLLER HEIGHT:

1.Remove the drive chain cover to access the roller adjustments on the drive chain side of the planer. A single socket head cap screw holds the drive chain cover on. Belt side adjustments are already accessible.

2.Loosen the roller adjustment check nuts and turn the roller height setscrews to change the height of the roller as needed. See Figure 20.

3.Check roller height according to the above instructions. Continue turning the setscrew until the roller is properly adjusted.

4.When the roller is set in the correct position, re-tighten the check nuts you loosened in Step 2 above.

5.Check your settings one last time and repeat steps 1-4 if necessary.

Figure 20. Feed roller height adjustment.

Feed Roller Pressure

To be effective, the infeed and outfeed rollers must put pressure on the workpiece as it feeds through the planer. Too little pressure results in slipping boards, too much pressure results in jamming.

Experiment with the best pressure settings for your work situations. Some rough cut lumber will feed through fine with relatively few problems, while other lumber will have more difficulty.

Adjusting roller pressure does not affect height.

TO ADJUST ROLLER PRESSURE:

1.Disconnect the machine from the power source.

2.Ensure that knives and feed rollers are set correctly.

3.Unscrew the four large pressure setscrews on top of the planer body. See Figure 21.

Light Pressure

Setscrew

Regular

Pressure

Setscrews

Figure 21. Roller pressure adjustment.

 

 

 

 

 

 

 

 

-22-

 

 

G1021 15" Planer

 

 

Image 22
Contents Planer Page Table Of Contents Adjustment Block Pattern Warranty and Returns Safety Safety Instructions For Power ToolsSafety Instructions For Power Tools Additional Safety Instructions For Planers 220V Operation Grounding FusingCircuit Requirements Extension CordsIntroduction CommentaryUnpacking Parts InventoryClean Up Site ConsiderationsOverview AssemblyOptional Stand Planer Unit Starter SwitchTo Mount the Planer To Assemble the Knife Setting JIG Handwheel Knife Setting JigTo Mount the Handwheel To Attach the Extension Rollers Extension Rollers Dust PortTo Attach the Dust Port Adjustments Overview of planer adjustment controls G1021 15 PlanerGauge Block Table AdjustmentTo Check Table Parallelism Knife Inspection To Inspect the KnivesKnife Setting To SET the KnivesTo Adjust the Chipbreaker Chip BreakerFeed Roller Height To Check Roller HeightTo Adjust Roller Pressure To Adjust Roller HeightFeed Roller Pressure To Adjust the BED Rollers Bed RollersTo Adjust the Chip Deflector Chip DeflectorTo INSPECT/ADJUST the Pulleys Anti-KickbackBeltsTo Check Belt Tension GearboxTo Inspect the Gearbox Extension Rollers Extension RollersTo Adjust the Scale Thickness ScaleOperations Table LocksHandwheel Power FeedDepth Limiter Test Run Wood Species Type Shear PSIPlaning Difficulties Maintenance GeneralKnivesLubrication Fill DrainAdjustment Section Closure Troubleshooting Symptom Possible Cause Corrective ActionReference 145 79 80 146 See page 41-42 for Reference Number Listing See page 41-42 for Reference Number Listing Pulley Cover PK06M G1021 15 Planer Warranty and Returns