Husqvarna DXR-310 manual What is what in the machine

Page 17

PRESENTATION

What is what in the machine

1.Hydraulic tank

2.Lubrication pump for lubricating the hammer (accessory)

3.Arm 1

4.Arm 2

5.Telescopic arm

6.Arm 3

7.Cylinders

8.Valve block

9.Slew motor

10.Tool attachment

11.Gear ring

12.Tensioning wheel

13.Screws for widening the tracks

14.Support wheel

15.Drive motor

16.Outrigger foot

17.Outrigger

18.Counterweight in the tower

19.Electric cabinet

20.Emergency stop

21.Warning light

22.Control module

23.Base plate

24.Lifting eye bolts

25.Electric motor

26.Radio module

27.Track unit

28.Hydraulic pump

29.Chassis beam

30.Cylinder guard

31.Inspection covers

32.Work lighting

33.Remote control

34.Communication cable

35.Harness

36.Battery charger

37.Track widener

38.Operator’s Manual

English - 17

Image 17

Contents

DXR-310 Page Contents Introduction Symbols on the machine KEY to SymbolsProtective equipment Safety InstructionsPersonal protective equipment Other protective equipmentManagement and operator General safety instructionsIf there is an accident ResponsibilityElectrical safety Work area safetyGeneral working instructions Machine’s risk areaOperation Personal safetyGeneral Education and trainingGeneral ManoeuvringOutriggers Rotation functionFalling material Towing Transport and storagePersonal protection Machine’s safety featuresMaintenance and service Mechanical protection External environmental factors TemperatureMoisture Dust and particlesMachine’s functions PresentationWhat is what in the machine General Hydraulic SystemMain pressure Pressure cut-offMachine’s hydraulic system Low-voltage circuit Electric SystemHigh-voltage circuit Machine’s electric system Battery Remote controlControl System Machine’s softwareWhat is what on the remote control Symbols on the remote control Before starting Starting and StoppingStarting StoppingOperation Key to commandsOperating modes Designation of the machine’s partsWork mode Track operation Set-up modeTransport mode Bucket ToolsHydraulic hammer Concrete cutterChanging tools CleaningFitting StorageFitting the track widener SettingsTrack widener Menu system LCD Adjustment Operational settingsTuning Software versionMaintenance and Service Cleaning method CleaningCleaning of components After washingDaily inspection Service scheduleMiscellaneous Weekly serviceChange Hours serviceAfter the Þrst 100 hours Lubrication Service reviewOutriggers and arm system Gear ringShafts MountingsTightening torque PosWear and damage Level checkCracks LeakageFunctional inspection Replenishing hydraulic ßuid ChangeDraining hydraulic ßuid Air Þlter Oil ÞlterError messages Trouble ShootingService messages Service messages and actions ActionFault Cause Possible action Trouble shooting guideEnglish Guide values for mains connection Technical DataHydraulic system’s pressure 50 HzHydraulic ßuid and lubricant Preset limit valuesHydraulic ßuid LubricantTechnical data Noise emissions Sound power levelMachine without tool Machine with tool hydraulic hammerEnglish Technical Data EC-declaration of conformity EC-DECLARATION of ConformityPage ´z+SXh¶6Q¨ Page 1151567-26 2009-03-16