Husqvarna DXR-310 manual Weekly service, Miscellaneous

Page 38

MAINTENANCE AND SERVICE

Weekly service

Carry out a daily inspection as per the service schedule before you carry out the weekly service.

Lubrication

Cylinders and shafts in lower part and outriggers

Drive, track sides and track tensioning

Gear ring

Cracks

Drive, track sides and track tensioning

Mountings

Drive, track sides and track tensioning

Power unit (motor, fan, fan housing)

Wear and damage

Cylinders and shafts in lower part and outriggers

Drive, track sides and track tensioning

Hoses

Leakage

Hoses

Other hydraulic components

Function

Drive, track sides and track tensioning

Cooler

Slew motor

Hammer lubrication

Emergency stop/machine stop

Miscellaneous

Clean the entire machine

Clean the cooler

38 - English

Image 38

Contents

DXR-310 Page Contents Introduction KEY to Symbols Symbols on the machinePersonal protective equipment Safety InstructionsProtective equipment Other protective equipmentIf there is an accident General safety instructionsManagement and operator ResponsibilityGeneral working instructions Work area safetyElectrical safety Machine’s risk areaGeneral Personal safetyOperation Education and trainingOutriggers ManoeuvringGeneral Rotation functionFalling material Transport and storage TowingPersonal protection Machine’s safety featuresMaintenance and service Mechanical protection Moisture TemperatureExternal environmental factors Dust and particlesPresentation Machine’s functionsWhat is what in the machine Main pressure Hydraulic SystemGeneral Pressure cut-offMachine’s hydraulic system Low-voltage circuit Electric SystemHigh-voltage circuit Machine’s electric system Control System Remote controlBattery Machine’s softwareWhat is what on the remote control Symbols on the remote control Starting Starting and StoppingBefore starting StoppingOperating modes Key to commandsOperation Designation of the machine’s partsWork mode Set-up mode Track operationTransport mode Hydraulic hammer ToolsBucket Concrete cutterFitting CleaningChanging tools StorageFitting the track widener SettingsTrack widener Menu system Tuning Operational settingsLCD Adjustment Software versionMaintenance and Service Cleaning of components CleaningCleaning method After washingService schedule Daily inspectionWeekly service MiscellaneousChange Hours serviceAfter the Þrst 100 hours Outriggers and arm system Service reviewLubrication Gear ringTightening torque MountingsShafts PosLevel check Wear and damageLeakage CracksFunctional inspection Replenishing hydraulic ßuid ChangeDraining hydraulic ßuid Oil Þlter Air ÞlterService messages Trouble ShootingError messages Service messages and actions ActionTrouble shooting guide Fault Cause Possible actionEnglish Hydraulic system’s pressure Technical DataGuide values for mains connection 50 HzHydraulic ßuid Preset limit valuesHydraulic ßuid and lubricant LubricantTechnical data Machine without tool Sound power levelNoise emissions Machine with tool hydraulic hammerEnglish Technical Data EC-DECLARATION of Conformity EC-declaration of conformityPage ´z+SXh¶6Q¨ Page 1151567-26 2009-03-16