Husqvarna DXR-310 manual EC-DECLARATION of Conformity, EC-declaration of conformity

Page 56

EC-DECLARATION OF CONFORMITY

EC-declaration of conformity

(Only applies to Europe)

Husqvarna Construction Products, SE-433 81 Göteborg, Sweden, tel: +46-31-949000, declares under sole respon- sibility that the Husqvarna DXR-310dating from 2009 serial numbers and onwards (the year is clearly stated on the rating plate, followed by the serial number), complies with the requirements of the COUNCIL’S DIRECTIVES:

-of June 22, 1998 “relating to machines” 98/37/EG, appendix IIA.

-of December 15, 2004 “relating to electromagnetic compatibility” 2004/108/EG.

-of December 12, 2006 “relating to electrical equipment” 2004/95/EG.

-of May 8, 2000 “relating to emission of noise to the surroundings” 2000/14/EG.

The following standards have been applied: EN ISO 12100-2.

Göteborg, March 16, 2009

Anders Ströby

President Husqvarna Construction Products

56 - English

Page 55 Page 57
Image 56
Page 55 Page 57
Contents
DXR-310 Page Contents Introduction KEY to Symbols Symbols on the machineSafety Instructions Protective equipmentPersonal protective equipment Other protective equipmentGeneral safety instructions Management and operatorIf there is an accident ResponsibilityWork area safety Electrical safetyGeneral working instructions Machine’s risk areaPersonal safety OperationGeneral Education and trainingManoeuvring GeneralOutriggers Rotation functionFalling material Transport and storage TowingPersonal protection Machine’s safety featuresMaintenance and service Mechanical protection Temperature External environmental factorsMoisture Dust and particlesPresentation Machine’s functionsWhat is what in the machine Hydraulic System GeneralMain pressure Pressure cut-offMachine’s hydraulic system Low-voltage circuit Electric SystemHigh-voltage circuit Machine’s electric system Remote control BatteryControl System Machine’s softwareWhat is what on the remote control Symbols on the remote control Starting and Stopping Before startingStarting StoppingKey to commands OperationOperating modes Designation of the machine’s partsWork mode Set-up mode Track operationTransport mode Tools BucketHydraulic hammer Concrete cutterCleaning Changing toolsFitting StorageFitting the track widener SettingsTrack widener Menu system Operational settings LCD AdjustmentTuning Software versionMaintenance and Service Cleaning Cleaning methodCleaning of components After washingService schedule Daily inspectionWeekly service MiscellaneousChange Hours serviceAfter the Þrst 100 hours Service review LubricationOutriggers and arm system Gear ringMountings ShaftsTightening torque PosLevel check Wear and damageLeakage CracksFunctional inspection Replenishing hydraulic ßuid ChangeDraining hydraulic ßuid Oil Þlter Air ÞlterTrouble Shooting Error messagesService messages Service messages and actions ActionTrouble shooting guide Fault Cause Possible actionEnglish Technical Data Guide values for mains connectionHydraulic system’s pressure 50 HzPreset limit values Hydraulic ßuid and lubricantHydraulic ßuid LubricantTechnical data Sound power level Noise emissionsMachine without tool Machine with tool hydraulic hammerEnglish Technical Data EC-DECLARATION of Conformity EC-declaration of conformityPage ´z+SXh¶6Q¨ Page 1151567-26 2009-03-16