Husqvarna DXR-310 manual Introduction

INTRODUCTION

Dear Customer

Thank you for choosing a Husqvarna DXR-310!

We hope you will Þnd this operator’s manual very use- ful. By following its instructions (on operation, service, maintenance, etc.) you will signiÞcantly extend the life of the machine and even its second-hand value.

Good service

Husqvarna products are sold all over the world and ensures that you, the customer, get the best support and service. When you need spare parts or advice on service or warranty issues, go to www.husqvarnacp. com and Þnd your local service agent.

Serial Number

The machine’s serial number is indicated on a plate located on the hydraulic tank. Stated on the plate are:

•The machine’s type designation

•Weight

•The manufacturer’s type number

•The machine’s serial number

•Manufacturer

The hydraulic pump and hydraulic motors are Þtted with rating plates that indicate article number and the machine manufacturer’s manufacture number.

Please state the type designation and serial number when ordering spare parts and for service matters.

Applications

The machine is intended for:

•Demolishing, fragmenting, cutting, detaching, separating, picking up and distributing parts of buildings and constructions.

•Use in risky environments where the operator can control the machine without being present within the risk area.

•Use both indoors and outdoors.

•Use in dangerous environments where the machine is exposed to risk of collapse, hazardous sub- stances, great heat, etc.

•Use in environments classiÞed as ’ßammable” provided that it has the correct power connection and all its equipment is correctly dimensioned and undamaged. The operator must take the risk of spark formation into consideration when working in ßammable environments..

The machine is NOT intended for:

•Use in areas classiÞed as ’explosive”.

•Use in water where the level risks damaging the machine’s equipment.

•Operation on a public highway.

•Use as a towing vehicle, means of transport or lift- ing device.

•Use in environments where there is danger for the operator or the life and health of people in the vicinity.

•Use in applications or environments that are not compatible with the recommendations in this Op- erator’s Manual.

User responsibility

It is the owner’s/employer’s responsibility that the op- erator has sufÞcient knowledge about how to use the machine safely. Supervisors and operators must have read and understood the Operator’s Manual. They must be aware of:

•The machine’s safety instructions.

•The machine’s range of applications and limita- tions.

•How the machine is to be used and maintained.

The manufacturer’s reservation

Husqvarna Construction Products reserves the right to alter speciÞcations and instructions for the machine without prior notiÞcation. The machine may not be modiÞed without the manufacturer’s written permis- sion. If the machine is modiÞed after delivery from Husqvarna Construction Products and without the manufacturer’s written permission, it is the owner’s responsibility.

ModiÞcation can entail new risks for operators, the machine and the surroundings. These can include impaired strength or inadequate protection. It is the responsibility of the owner to specify which altera- tions are going to be made and to contact the supplier of the machine for approval before commencing the modiÞcations.

All information and all data in the Operator’s Manual were applicable at the time the Operator’s Manual was sent to print.

Contact

Husqvarna Construction Products, Jons väg 19, SE-433 81 Göteborg, Sweden.

4 - English