Miller Electric ICE-27T, 375 X-TREME manual Connecting Gas/Air Supply, Connecting Work Clamp

Page 15

.A complete Parts List is available at www.MillerWelds.com

4-6. Connecting Gas/Air Supply

1

3

Tools Needed:

9/16 in

2

From Gas/Air

Supply

.Use only clean, dry air with 90 to 120 psi (621 to 827 kPa) pressure.

1Gas/Air Inlet Opening

2Hose

3Teflon Tape

Obtain hose with 1/4 NPT right- hand thread fitting. Wrap threads with teflon tape (optional) or apply pipe sealant, and install fitting in opening. Route hose to gas/air supply.

4-7. Connecting Work Clamp

1

2

804 505-A

1 Work Clamp

2 Workpiece

Connect work clamp to a clean, paint-free location on workpiece, as close to cutting area as possible.

802 463-A

OM-225 216 Page 11

Image 15

Contents File Plasma Cutters OM-225 216FProcesses DescriptionFrom Miller to You Table of Contents Page Cutting can cause fire or explosion Symbol UsageMarks a special safety message Plasma Arc Cutting HazardsNoise can damage hearing Exploding Parts can injureFlying Sparks can cause injury ARC Rays can burn eyes and skinCalifornia Proposition 65 Warnings Principal Safety Standards EMF InformationAbout Pacemakers Identifie un message de sécurité particulier Signification des symbolesLE Coupage présente un risque de feu ou d’explosion UNE Décharge Électrique peut entraîner la mortLE Plasma D’ARC peut entraîner des blessures Risque de blessure en casLE Bruit peut endommager l’ouïe LES Fumées ET LES GAZ peuvent être dangereuxRisque D’INCENDIE OU DES Pieces Chaudes peuvent pro- voquer des brûlures gravesDES Organes Mobiles peuvent provoquer des blessures LA Chute DE L’APPAREIL peut blesserConsignes relatives aux stimulateurs cardiaques Principales normes de sécuritéInformation sur les champs électromagnétiques LE Coupage Ã L’ARC peut causer des interférenceSymbols And Definitions SpecificationsSpecifications For Torch Power Source Dimensions And Weight Torch Dimensions And WeightDuty Cycle And Overheating Connecting Work Clamp Connecting Gas/Air SupplyInput Voltage 240 Input Amperes At Rated Output Electrical Service Guide For 240 VACExtension Cord Data 60 HzConnecting 1-Phase Input Power For 240 VAC 460 mm Connecting Input PowerControls − OperationCutting Speed Trigger Safety LockPilot arc starts immediately When trigger is pressedSequence Of Operation Example Of Cutting OperationOverload Protection Routine MaintenanceRemoving wrapper Wrapper Torx Screws Fine Thread Wrapper RemovalTurn Off Wrapper Check BusDC Bus Voltage Check Checking Or Replacing Filter Element Shield Cup Checking Torch Shield Cup Shutdown SystemChecking/Replacing Retaining Cup, Tip, And Electrode Turn Off power source before checking torch partsTorch And Work Cable Connections Torch ConnectionsWork Cable Connections OM-225 216 − Electrical Diagram 224 682-B Recommended Spare Parts Recommended Spare PartsOM-225 216 Page Support ServiceMiller Electric Mfg. Co Owner’s Record