Miller Electric ICE-27T, 375 X-TREME manual Wrapper Removal, Turn Off, Wrapper Check Bus

Page 23

.A complete Parts List is available at www.MillerWelds.com

6-3. Wrapper Removal

	Y Turn		off	power,	and
		disconnect input power plug
		from	receptacle		before
		working on unit.
	Y Significant DC voltage can
		remain on capacitors after unit
2		is Off. Wait until all front panel
		LED’s are off before removing
		wrapper.
1	Y Check		DC	bus	voltage
		according to Section 6-4after

		removing wrapper.
	1	Wrapper
	2 Torx Screws (Fine Thread)

Remove Torx screws and slide wrapper off.

Tools Needed:

Torx 25

Ref. 804 505-A

OM-225 216 Page 19

Image 23

Contents File Plasma Cutters OM-225 216FProcesses DescriptionFrom Miller to You Table of Contents Page Cutting can cause fire or explosion Symbol UsageMarks a special safety message Plasma Arc Cutting HazardsNoise can damage hearing Exploding Parts can injureFlying Sparks can cause injury ARC Rays can burn eyes and skinCalifornia Proposition 65 Warnings About Pacemakers Principal Safety StandardsEMF Information Identifie un message de sécurité particulier Signification des symbolesLE Coupage présente un risque de feu ou d’explosion UNE Décharge Électrique peut entraîner la mortLE Plasma D’ARC peut entraîner des blessures Risque de blessure en casLE Bruit peut endommager l’ouïe LES Fumées ET LES GAZ peuvent être dangereuxRisque D’INCENDIE OU DES Pieces Chaudes peuvent pro- voquer des brûlures gravesDES Organes Mobiles peuvent provoquer des blessures LA Chute DE L’APPAREIL peut blesserConsignes relatives aux stimulateurs cardiaques Principales normes de sécuritéInformation sur les champs électromagnétiques LE Coupage Ã L’ARC peut causer des interférenceSpecifications For Torch Symbols And DefinitionsSpecifications Duty Cycle And Overheating Power Source Dimensions And WeightTorch Dimensions And Weight Connecting Work Clamp Connecting Gas/Air SupplyInput Voltage 240 Input Amperes At Rated Output Electrical Service Guide For 240 VACExtension Cord Data 60 HzConnecting 1-Phase Input Power For 240 VAC 460 mm Connecting Input PowerControls − OperationCutting Speed Trigger Safety LockPilot arc starts immediately When trigger is pressedSequence Of Operation Example Of Cutting OperationOverload Protection Routine MaintenanceRemoving wrapper Wrapper Torx Screws Fine Thread Wrapper RemovalTurn Off Wrapper Check BusDC Bus Voltage Check Checking Or Replacing Filter Element Shield Cup Checking Torch Shield Cup Shutdown SystemChecking/Replacing Retaining Cup, Tip, And Electrode Turn Off power source before checking torch partsWork Cable Connections Torch And Work Cable ConnectionsTorch Connections OM-225 216 − Electrical Diagram 224 682-B Recommended Spare Parts Recommended Spare PartsOM-225 216 Page Support ServiceMiller Electric Mfg. Co Owner’s Record

6-3. Wrapper Removal

Y Turn

off

wrapper.

Y Check

bus

removing wrapper.

Wrapper

2 Torx Screws (Fine Thread)