Miller Electric ICE-27T, 375 X-TREME manual Checking Or Replacing Filter Element

Page 25

.A complete Parts List is available at www.MillerWelds.com

6-5. Checking Or Replacing Filter Element

Y Check DC bus voltage according to Section 6-4,and be sure voltage is near zero before touching any parts.

Turn power Off, and disconnect input power plug from receptacle. Remove wrapper from unit (see Section 6-3).

1 Filter Base

2 Filter

3 Filter Cup

Unscrew filter cup from base.

Remove cup.

Unscrew filter element from base.

Check filter element for dirt and moisture, and replace if necessary.

Be sure that all parts are clean and dry.

Reinstall filter element, and secure filter cup.

Reinstall wrapper.

Tools Needed:

Torx 25

804 506-B

OM-225 216 Page 21

Image 25

Contents Processes OM-225 216FDescription File Plasma CuttersFrom Miller to You Table of Contents Page Marks a special safety message Symbol UsagePlasma Arc Cutting Hazards Cutting can cause fire or explosionFlying Sparks can cause injury Exploding Parts can injureARC Rays can burn eyes and skin Noise can damage hearingCalifornia Proposition 65 Warnings EMF Information Principal Safety StandardsAbout Pacemakers LE Coupage présente un risque de feu ou d’explosion Signification des symbolesUNE Décharge Électrique peut entraîner la mort Identifie un message de sécurité particulierLE Bruit peut endommager l’ouïe Risque de blessure en casLES Fumées ET LES GAZ peuvent être dangereux LE Plasma D’ARC peut entraîner des blessuresDES Organes Mobiles peuvent provoquer des blessures DES Pieces Chaudes peuvent pro- voquer des brûlures gravesLA Chute DE L’APPAREIL peut blesser Risque D’INCENDIE OUInformation sur les champs électromagnétiques Principales normes de sécuritéLE Coupage Ã L’ARC peut causer des interférence Consignes relatives aux stimulateurs cardiaquesSpecifications Symbols And DefinitionsSpecifications For Torch Torch Dimensions And Weight Power Source Dimensions And WeightDuty Cycle And Overheating Connecting Work Clamp Connecting Gas/Air SupplyExtension Cord Data Electrical Service Guide For 240 VAC60 Hz Input Voltage 240 Input Amperes At Rated OutputConnecting 1-Phase Input Power For 240 VAC 460 mm Connecting Input PowerControls − OperationCutting Speed Trigger Safety LockSequence Of Operation When trigger is pressedExample Of Cutting Operation Pilot arc starts immediatelyOverload Protection Routine MaintenanceTurn Off Wrapper RemovalWrapper Check Bus Removing wrapper Wrapper Torx Screws Fine ThreadDC Bus Voltage Check Checking Or Replacing Filter Element Shield Cup Checking Torch Shield Cup Shutdown SystemChecking/Replacing Retaining Cup, Tip, And Electrode Turn Off power source before checking torch partsTorch Connections Torch And Work Cable ConnectionsWork Cable Connections OM-225 216 − Electrical Diagram 224 682-B Recommended Spare Parts Recommended Spare PartsOM-225 216 Page Support ServiceMiller Electric Mfg. Co Owner’s Record