Chapter 4 | Advanced Configuration |
Host Name Enter your host name in the three Host Name fields. For example, if your host name were myhouse.3322. org, then myhouse would go into the first field, 3322 would go into the second field, and org would go into the last field.
Click Save Settings, and the status of the DDNS function will be updated.
Oray.net PeanutHull DDNS
Setup > DDNS > Oray.net PeanutHull DDNS
User name Enter your PeanutHull account information. Password Enter your PeanutHull account information.
Host Name Enter your host name in the three Host Name fields. For example, if your host name were myhouse. oray.net, then myhouse would go into the first field, oray would go into the second field, and net would go into the last field.
Click Save Settings, and the status of the DDNS function will be updated.
Internet IP Address The Router’s current Internet IP address is displayed. Because it is dynamic, this will change.
Status The status of the DDNS function is displayed. If the status information indicates an error, make sure you have correctly entered the information for your account with your DDNS service.
Click Save Settings to save your changes, or click Cancel Changes to undo them.
Setup > Advanced Routing
The Advanced Routing screen allows you to configure the dynamic and static routing settings.
Setup > Advanced Routing
Advanced Routing
Dynamic Routing
The Router’s dynamic routing feature can be used, so the Router will automatically adjust to physical changes in the network’s layout. Using the dynamic RIP protocol, the Router calculates the most efficient route for the network’s data packets to travel between the source and the destination, based upon the shortest paths. The RIP protocol regularly broadcasts routing information to other routers on the network. It determines the route that the network packets take based on the fewest number of hops between the source and the destination.
Working Mode Select Gateway mode if the Router is hosting your network’s connection to the Internet. Select Router mode if the Router exists on a network with other routers, including a separate network gateway that handles the Internet connection. In Router mode, any computer connected to the Router will not be able to connect to the Internet unless you have another router function as the gateway.
RIP (Routing Information Protocol) To use dynamic routing for communication of network data, select Enabled. Otherwise, keep the default, Disabled.
Receive RIP versions To use dynamic routing for reception of network data, select the protocol you want: None, RIPv1, RIPv2, or Both RIP v1 and v2.
Transmit RIP versions To use dynamic routing for transmission of network data, select the protocol you want: None, RIPv1, RIPv2 - Broadcast, or RIPv2 - Multicast.
10/100 | 18 |