ENGLISH
Fitting the dust extraction adaptor (fig. C)
Adjusting the depth of cut (fig. H, I & J)
The dust extraction adaptor allows you to connect a vacuum cleaner to the tool.
•Connect the hose (18) of the vacuum cleaner to the adaptor (11).
Fitting the template guide (fig. D)
•Fit the template guide (19) to the base of the router, with the flange to the bottom (workpiece) side.
•Insert the two long screws (20) from the bottom side through the template guide and the holes in the base.
•Place a nut onto each of the screws and securely tighten the nuts.
Fitting the distance piece (fig. E)
•Fit the distance piece (21) to the base of the router using the screws provided.
Fitting the centring pin (fig. F)
•Fit the edge guide to the router as shown in fig. B, but upside down.
•Fit the centring pin (22) to the workpiece side of the edge guide with the screw (23) provided.
Fitting the copy follower (fig. G)
The depth of cut is the distance X between the depth stop bar
(9)and the depth stop (27). The depth of cut can be set in two different ways as described below.
Adjusting the depth of cut using the scale (fig. I)
•Fit the router bit as described above.
•Loosen the locking screw (28).
•Pull the plunge lock lever (4) up.
•Plunge the router down until the router bit touches the workpiece.
•Push the plunge lock lever (4) down.
•Move the pointer (29) in the zero position on the scale
(10).
•Add the desired depth of cut to the starting position.
•Move the depth stop bar (9) to the calculated position on the scale.
•Tighten the locking screw (28).
•Fine adjust using the adjusting knob (30).
•Pull the plunge lock lever (4) up and let the router return to its original position.
•After switching the router on, plunge it down and make the desired cut.
•Fit the edge guide to the router as shown in fig. B.
•Fit the ‘L' bar (24) to the upper side of the edge guide using the two screws and nuts provided.
•Adjust the rotating attachment (25) on the ‘L' bar with the wing knob (26).
Use
Warning! Let the tool work at its own pace. Do not overload.
•Carefully guide the cable in order to avoid accidentally cutting it.
Adjusting the depth of cut using a piece of wood (fig. J)
•Fit the router bit and plunge the router down as described above.
•Pull the depth stop bar (9) up.
•Place a piece of wood with a thickness equal to the desired depth of cut between the depth stop (27) and the depth stop bar (9).
•Tighten the locking screw (28).
•Fine adjust using the adjusting knob (30).
10