OPERATING INSTRUCTIONS
CAUTION! Always use safety equipment. Wear
CAUTION! Always secure the workpiece in place, using a vise or clamps (not included).
1.Make sure the Power Switch (27) is in its “OFF” position. Then, plug the Power Cord/Plug (15) into the nearest 120 volt, grounded, electrical outlet.
(See Figure E.)
2.Keep the Belt Sander off the work surface. Then, squeeze the Power Switch (27) to start the tool. If desired, use the Lock Button (14) to lock the Power Switch in its continuous run mode. (See Figure E.)
3.Place the heel of the Belt Sander on the work surface first. Then with a forward motion, begin sanding as the tool is lowered onto the work surface.
4.Move the Belt Sander slowly back and forth across the work surface, using short, overlapping strokes.
5.Do not apply excessive pressure on the Belt Sander. Too much pressure will over- load the motor and reduce Sanding Belt (66) speed. Avoid tilting or rocking the Belt Sander or sanding in one spot for too long.
6.Begin sanding with a coarser grit Sandpaper and gradually use finer grits until the desired finish on the work surface is achieved.
7.When finished sanding, lift the Belt Sander off the work surface. Squeeze the Power Switch (27) to disengage the Lock Button (14) and turn off the Sander.
8.Allow the Belt Sander to come to a complete stop before setting the tool down.
9.Unplug the Power Cord/Plug (15) from its electrical outlet.
10.Make sure to store the Belt Sander in a clean, dry, safe location out of reach of children and other unauthorized people.
SKU 94748 | For technical questions, please call | PAGE 11 |