Craftsman 113.225931, 113.225909, 113.225900 manual Curved Edges

Page 21

FINISHING CURVED EDGES ON THE

ABRASIVE BELT

CURVED EDGES

Finish outside curves on the abrasive belt and inside

curves on the idler pulley.

FINISHING SMALL END SURFACES AND CURVED EDGES ON THE ABRASIVE DISC

Move the work across the "Down Side" of the face of the abrasive disc. For accuracy, use a miter gauge_

NOTE: Use a combination square to square the miter gauge to the face of the disc. If it is not squat e pull out the index pin, loosen the miter gauge knob and move the

miter gauge slightly until it is square. Without moving the miter gauge, tighten the knob securely.

Applying the workpiece to the "Up Side" could cause it to fly up (kickback) which could be hazardous.

The table may be tilted for beveled work.

SQUARE

	"_	MITER GAUGE
	\	MITER GAUGE
	\

Image 21

Contents Legs and Motor Belt and DiscPower tools General safety instructionsBefore Using the Sander Before Each USESander Whenever Sander is Running Plan your workAt a time Connecting to Power Source Outlet ProperlyGrounded /n Ul OUTLETs Unpacking and checking ContentsAssernbJy HAROWABEFORMOUNTINGTOOL& MotorFollowing parts are included with Model Catalog no Mounting Belt and Disc Sander on Craftsman Steel LEG SETAssembly Installing Sanding Disc and Dust TrapWrench Belt Table LockingFlat Spot AssemblyDisc Dust Trap Flat Head Screws TrapTWO Holes TOP Right Hand Screw Dust Trap CoverClips 10-32 X 1/2ON-OFF Switch AssemblyInsert key into switch Place the bolt onto the motor pulley by rotating the pulleyPower Cord Motor Cord CableFind plastic cable hanger from among the loose parts Directional ARROW\ Be LT Adjusting SCR EWS Installing Work TablePull Wrenches in this Direction to Apply Tension Belt Locking ScrewBelt Leftmoving To Right Installing Belt Dust TrapBelt Locking Screw Drive PulleyAssembWy Installing BackstopGetting to know your belt and disc sander ANY Aojustm EntsFrom Disc Positioning Lock Screw Stop Tilt Lock NUT Belt Adjusting Screw ONE on Each SideGe ng to know you r belt and disc sander Raise the table and loosen the lock nut using a 7/16 wrenchPlace. It is locked uing the 1/2 wrench Lock NUtBefore Using the Sander Basic operationBefore Each USE Before freeing any jammed material Surface Finishing on Abrasive BeltFor finishing long pieces, remove the backstop END Finishing on Abrasive BeltCurved Edges Sears Recommends Following Accessories Motor Maintenance LubricationCausing thebelt to sli CAT. noBox Motor wd! notProtector Open, only TooTrouble Shooting -- Motor RemedyLOW Voltage Parts List Supplied WithHardware for Mounting Tool & Motor Craftsman Belt and Disc Sander Model no .225900 & 113,225931 47222 Housing, DiscRepair parts Key Part DescriptionWith Plug Outlet Before Proceeding Black Wire to Terminal T1 Green Wire to Green ScrewRepair parts Switch MountingDoes Not Include Key No, 3. Order Separately If Required Page BEL T and Disc Sander