Craftsman 113.225900 Motor wd! not, Box, Protector Open, only, Too, Applying, Not, Tension, Sap

trouble shooting

WARNING: FOR YOUR OWN SAFETY, TURN

SWITCH "OFF" AND REMOVE PLUG FROM

POWER SOURCE OUTLET BEFORE TROUBLE

SHOOTING YOUR SANDER,

TROUBLE SHOOTING CHART

TROUBLE						PROBABLE			CAUSE
Motor wd! not		run.	1,	Defective On-Off switch.
				Defective			switch		cord.
				Defective			switch		box	receptacle,
			2,	Motor		protector			open, (only		if
				your motor is equipped with an
				overload			protector),
			3.	Burr_ed out motor.
Machine	slows	down	1.	V-Belt		too		loose.
when finishing,
			2.	Applying			too much pressure				to
				workpiece.
			3.	Too much tension on abrasive
				belt.
Abrasive	Belt	Slips	1,	Not	enough			tension.
Abrasive	Belt	runs	1.	Not	tracking			properly.
off pulleys.
			2.	Not	enough			tension.
Wood burnswhile			1.	Abrasive			disc or belt			is glazed	with
finishing.				sap.

REMEDY

1. Replace defective pa_ts before ,4sing b!!l_ dsc sai_(ler agai_

2. Reset p_otector after motor has cooled

3.Coqsuit S_!a!s S_!TvI(;e, Ally attemt.)t ._o lepa_ this

motor may £reate a HAZARD urtfe_s r_;t_air ts clon_ by a qualified service techr_icia_. Repair service is available at your nearest Sears Store.

1.Increase belt tension, see Assembly Section, "Motor Pulley Belt Gtlard and Motor InstaUation."

2.Ease up on pressure.

3, Adjust tension, see Assembly Section, "fnstaliing and Adjusting Abrasive _3elt."

1.Adjust tension, see Assembly Section, "Installing and Adjusting Abrasive Belt."

1, Adjust tracking, see Assembly Section, "'Installing and Adjusting Abrasive Belt."

2.Adjust tension, see Assembly Section. "Installing and Adjusting Abrasive Belt."

t. Replace dis(: or belt.

23