Grizzly w1702 Adjustments, Fence Positioning, To adjust the fence, do these steps

Page 18

ADJUSTMENTS

Fence Positioning

ADJUSTMENTS

The two fence faces are independently adjustable to allow for different shaping tasks. The fence faces can be set at different positions to remove material from the entire edge of the wood stock or the same position to allow the shaping of part of the edge.

To adjust the fence, do these steps:

1.Loosen the fence mount lock handle located on the side of the fence mount shown in

Figure 22.

2.Adjust the position of the fence by turning the adjustment knob located on the back of the fence mount shown in Figure 22.

3.Once the fence is in the desired position, tighten down the fence mount lock handle.

UNPLUG the power cord before you do any assembly, adjustments, or maintenance tasks! Otherwise, serious personal injury to you or others may occur!

KEEP loose clothing rolled up and out of the way of machinery and keep hair pulled back.

WEAR your safety goggles during any machine assembly, operation, or maintenance. Failure to comply may result in serious personal injury.

Fence Mount

Lock Handle

Adjustment

Knob

Figure 22. Fence mount lock handle.

NOTICE

You can adjust the relative position of the fence mount lock handle head by pulling and rotating the head either clockwise or counter-clockwise. Adjusting the relative position is sometimes necessary before tightening or loosening the handle in tight locations.

NOTICE

DO NOT over-tighten screws or bolts into the cast iron. Cast iron threads strip more easily than steel.

-16-

Image 18

Contents HP Shaper Page Contents Woodstock Service and Support IntroductionAbout Your New Shaper Warranty and Returns SpecificationsSafety Standard Safety InstructionsSafety Additional Safety Instructions for Shapers Avoiding Potential Injuries Use a Shop FOX Featherboard asExtension Cords Electrical220V Operation GroundingAssembly UnpackingInventory Initial Cleaning BeginningDust Collection Shop PreparationSafety Guard Fence FacingAuxiliary Guard Hold-Downs To install the hold-downs, do these stepsTo install the crank handle, do these steps HandwheelSpindle Unplug the ShaperThreading drawbar nut onto drawbar Adjustments To adjust the fence, do these stepsFence Positioning Fence Alignment To adjust the table inserts, do these steps Table InsertsPulley Alignment To align the pulleys, do these stepsSpindle RPM Choose Spindle RPMTo change the spindle RPM, do these steps Spindle Slide and Gib To check the spindle slide-to-gib clearance, do these stepsOperations Start UpForward and reverse switch Cutter DirectionChoose Cutter Height and Spindle Size Cutter InstallationChoose Cutter Profile and Cutter Choose Spindle and Cutter RPMPlace the spindle washer onto the spindle as shown in Figure Setting Spindle Height To set the spindle height, do these stepsStraight Shaping Operations There are three set up positions for rub collars Rub CollarsFreehand Shaping Starting pin operation Guard not shown for clarityPattern Shaping To make a template, do these stepsTable and Base MaintenanceGeneral LubricationTroubleshooting Closure Model W1702 220V Wiring Diagram Parts Stand Parts Handle Parts XPR15M Parts XPW02 Lock Washer 3⁄8 Parts Miter Gauge Body HOLD-DOWN BAR Shaper Accessories Shaper Accessories Your Notes Your Notes Warranty Card BOX BELLINGHAM, WA