Grizzly w1702 instruction manual Fence Alignment

Page 19

Fence Alignment

Figure 23. Use straightedge to check fence.

Before shaping, check that the two fence faces are parallel.

To align the fences so they are parallel with each other, do these steps:

1.Get a quality straightedge that is long enough to span the entire length of the fence assembly.

2.Make sure that the screws that hold the fence faces to the fence mounts are tight and secure.

3.Adjust the fence faces so they are in as close to the same parallel position as possible.

4.Hold the straightedge across both of the fence faces as shown in Figure 23.

5.If the fence faces are not parallel, place shims between the back of the fence pieces and the face of the fence mounts. With some trial and error shim adjusting, parallel fence faces can be achieved.

ADJUSTMENTS

-17-

Image 19

Contents HP Shaper Page Contents Introduction Woodstock Service and SupportAbout Your New Shaper Specifications Warranty and ReturnsStandard Safety Instructions SafetySafety Additional Safety Instructions for Shapers Use a Shop FOX Featherboard as Avoiding Potential InjuriesGrounding Electrical220V Operation Extension CordsUnpacking AssemblyInventory Beginning Initial CleaningShop Preparation Dust CollectionFence Facing Safety GuardAuxiliary Guard Handwheel To install the hold-downs, do these stepsTo install the crank handle, do these steps Hold-DownsUnplug the Shaper SpindleThreading drawbar nut onto drawbar To adjust the fence, do these steps AdjustmentsFence Positioning Fence Alignment Table Inserts To adjust the table inserts, do these stepsTo align the pulleys, do these steps Pulley AlignmentChoose Spindle RPM Spindle RPMTo change the spindle RPM, do these steps To check the spindle slide-to-gib clearance, do these steps Spindle Slide and GibStart Up OperationsCutter Direction Forward and reverse switchChoose Spindle and Cutter RPM Cutter InstallationChoose Cutter Profile and Cutter Choose Cutter Height and Spindle SizePlace the spindle washer onto the spindle as shown in Figure To set the spindle height, do these steps Setting Spindle HeightStraight Shaping Operations Rub Collars There are three set up positions for rub collarsStarting pin operation Guard not shown for clarity Freehand ShapingTo make a template, do these steps Pattern ShapingLubrication MaintenanceGeneral Table and BaseTroubleshooting Closure Model W1702 220V Wiring Diagram Parts Stand Parts Handle Parts XPR15M Parts XPW02 Lock Washer 3⁄8 Parts Miter Gauge Body HOLD-DOWN BAR Shaper Accessories Shaper Accessories Your Notes Your Notes Warranty Card BOX BELLINGHAM, WA