Grizzly w1702 instruction manual Spindle, Unplug the Shaper

Page 16

ASSEMBLY

Spindle

The Model W1702 comes with 1⁄2", 3⁄4", and 1" shaper spindles. Also available is a Model D3392 Optional Router Bit Spindle. It is very important that any spindle you use, is seated securely into the shaper so that safety is maintained.

To install the shaper spindle or router bit spindle, do these steps every time in the order below:

NOTICE

Make sure you remove any rust inhibiting oil or contamination from the spindle, the drawbar, and the spindle cartridge mating surfaces before you install spindles.

1.UNPLUG THE SHAPER!

2.Thread one end of the drawbar into the bottom end of the desired spindle as shown in Figure 18, approximately 10-15 turns until tight.

3.Insert the spindle/drawbar assembly into the spindle cartridge from the top side of the table. See Figure 19

4.Observe and make sure the spindle keyway on the spindle lines up with the guide pin on the spindle cartridge as shown in Figure 19.

5.Lower the spindle/drawbar assembly until the guide pin splines with the spindle keyway and the spindle/drawbar assembly fully seats into the tapered bore of the spindle cartridge. When correctly installed, you will feel the spindle/drawbar assembly seat snugly with the spindle cartridge.

Make certain the spindle keyway and pin are aligned and properly seated before tightening the drawbar nut. Improper assembly can create an unsafe condition and possibly injure the operator.

Figure 18. Threading drawbar into spindle.

Figure 19. Spindle and guide pin alignment.

-14-

Page 15 Page 17
Image 16
Page 15 Page 17
Contents HP Shaper Page Contents Introduction Woodstock Service and SupportAbout Your New Shaper Warranty and Returns SpecificationsSafety Standard Safety InstructionsSafety Additional Safety Instructions for Shapers Avoiding Potential Injuries Use a Shop FOX Featherboard asElectrical 220V OperationExtension Cords GroundingUnpacking AssemblyInventory Initial Cleaning BeginningDust Collection Shop PreparationFence Facing Safety GuardAuxiliary Guard To install the hold-downs, do these steps To install the crank handle, do these stepsHold-Downs HandwheelSpindle Unplug the ShaperThreading drawbar nut onto drawbar To adjust the fence, do these steps AdjustmentsFence Positioning Fence Alignment To adjust the table inserts, do these steps Table InsertsPulley Alignment To align the pulleys, do these stepsChoose Spindle RPM Spindle RPMTo change the spindle RPM, do these steps Spindle Slide and Gib To check the spindle slide-to-gib clearance, do these stepsOperations Start UpForward and reverse switch Cutter DirectionCutter Installation Choose Cutter Profile and CutterChoose Cutter Height and Spindle Size Choose Spindle and Cutter RPMPlace the spindle washer onto the spindle as shown in Figure Setting Spindle Height To set the spindle height, do these stepsStraight Shaping Operations There are three set up positions for rub collars Rub CollarsFreehand Shaping Starting pin operation Guard not shown for clarityPattern Shaping To make a template, do these stepsMaintenance GeneralTable and Base LubricationTroubleshooting Closure Model W1702 220V Wiring Diagram Parts Stand Parts Handle Parts XPR15M Parts XPW02 Lock Washer 3⁄8 Parts Miter Gauge Body HOLD-DOWN BAR Shaper Accessories Shaper Accessories Your Notes Your Notes Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents