Grizzly w1702 instruction manual Operations, Start Up

Page 24

OPERATIONS

Start Up

Once assembly is complete and adjustments have been made, the shaper is ready for start up. Always pay attention to any unusual noises and vibrations on every start up, as well as make sure the shaper operates as intended.

1.MAKE SURE that the fence, any accessories, Jigs, spindle, cutter, or router bit adapter being used is tight and no loose items are on the table.

2.Put your safety glasses on, and start the shaper by turning the switch to the forward position. Be sure to have your finger poised to stop the machine if there is a problem.

3.Once the machine is running, listen for any unusual noises coming from the shaper. The shaper should run smoothly with little or no vibrations.

•If there is an unusual noise or vibration, shut the machine off immediately. DO NOT run the shaper any further until the problems are corrected. Refer to the

Troubleshooting section on Page 33 for possible causes and solutions.

•If the problem continues and cannot be easily identified, contact our customer service department.

OPERATIONS

UNPLUG the power cord before you do any assembly, adjustments, or maintenance tasks! Otherwise, serious personal injury to you or others may occur!

KEEP loose clothing rolled up and out of the way of machinery and keep hair pulled back.

WEAR your safety glasses and dust mask during machine operation. Failure to comply may result in serious personal injury.

-22-

Image 24

Contents HP Shaper Page Contents Woodstock Service and Support IntroductionAbout Your New Shaper Warranty and Returns SpecificationsSafety Standard Safety InstructionsSafety Additional Safety Instructions for Shapers Avoiding Potential Injuries Use a Shop FOX Featherboard asElectrical 220V OperationExtension Cords GroundingAssembly UnpackingInventory Initial Cleaning BeginningDust Collection Shop PreparationSafety Guard Fence FacingAuxiliary Guard To install the hold-downs, do these steps To install the crank handle, do these stepsHold-Downs HandwheelSpindle Unplug the ShaperThreading drawbar nut onto drawbar Adjustments To adjust the fence, do these stepsFence Positioning Fence Alignment To adjust the table inserts, do these steps Table InsertsPulley Alignment To align the pulleys, do these stepsSpindle RPM Choose Spindle RPMTo change the spindle RPM, do these steps Spindle Slide and Gib To check the spindle slide-to-gib clearance, do these stepsOperations Start UpForward and reverse switch Cutter DirectionCutter Installation Choose Cutter Profile and CutterChoose Cutter Height and Spindle Size Choose Spindle and Cutter RPMPlace the spindle washer onto the spindle as shown in Figure Setting Spindle Height To set the spindle height, do these stepsStraight Shaping Operations There are three set up positions for rub collars Rub CollarsFreehand Shaping Starting pin operation Guard not shown for clarityPattern Shaping To make a template, do these stepsMaintenance GeneralTable and Base LubricationTroubleshooting Closure Model W1702 220V Wiring Diagram Parts Stand Parts Handle Parts XPR15M Parts XPW02 Lock Washer 3⁄8 Parts Miter Gauge Body HOLD-DOWN BAR Shaper Accessories Shaper Accessories Your Notes Your Notes Warranty Card BOX BELLINGHAM, WA